Routing

I have a question about MPLS. We currently have 3 sites internationally, with the main site in NY. Both sites are connected to NY with a private line (a T1 and a Layer 2 Ethernet connection). All three sites have their own internet connection, so ...

Hi Expertise,I have web server which is placed in my own network. I got WAN link form two different ISP let say ISP-A & ISP-B. My web server is resigster on ISP-A. Let suppose ISP-A gets down, i want my traffice redirect to ISP-B and that web server ...

Hi,I've a pb on my router that often comes to CPU 100 %.After troubleshoot, i've found that this pb is due to "interrupts" and I suspect my NAT rule to be not enough restrictive or false.What I need to do is to send UDP trafic (port 5060-5070) to IP ...

We had to upgrade from a 1700 series router to 2801 router. The 1700 router had a WIC-1T with an external CSU/DSU. This was replaced with a 2801 router with VWIC-1MFT-T1 card (integrated CSU/DSU). The idea is to elimiate external CSU/DSU. There was a...

Dear All,I would like to ask you some question: i had Cisco Router 1801 and i was create 2Vlan, is Vlan 10 and Vlan 20. So i would like to use DHCP on Vlan 10 and use DHCP on Vlan 20 .is it support on Router 1801 and Which command that i can create D...

Hello guys,I had my two T1/s went down in the same time/minute/sec this morning, they came back up in exactly 25 minutes. I am attaching the output of sh int sx/x/x.I see a lot of resets on these interface.Considering the attachment what could be the...

I connect two customers to my customer facing router using sub-interfaces. I used rate limiting to assign bandwidth to these customers as shown below:interface FastEthernet0/1.1 description CONNECTION 30Mbps NETWORKS encapsulation dot1Q 10 ip address...

Hi,We have a Cisco 876 router with a BRI S/T interface. We also bought a converter which can convert the S/T to a U interface. Unfortunately after plugging in the converter, Router S/T to Converter S/T out the Converter U to the ISDN patch port, we ...

Hello,I am trying to migrate an EIGRP network to OSPF. I thought I would do this by enabling OSPF across the network with admin dist of 180, then drop the AD on the Area 0 routers to get OSPF working in the core, then do the same in the leaf areas. ...

The error Description is listed below.Cisco IOS Software, 2800 Software (C2800NM-ENTSERVICESK9-M), Version 12.4(3h), RELEASE SOFTWARE (fc2)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2007 by Cisco Systems, Inc.Compiled Wed 2...

Please I configured a Class based weighted fair queueing on a cisco 3845 router with the following image c3845-advipservicesk9-mz.124-3g.bin. I applied it on a tunnel interface and it returned with the following error. (Class Based Weighted Fair Queu...

Hello everybody, I give you my problem: My ultimate goal is to have a load-balancing using one router 2811(two WAN interfaces and one fastethernet), for that I use route-map. For the moment something is not implemented, Indeed, if my WAN interface is...