Routing

Hello,I need to connect to the server (pop3, smtp, remote) in the inside network using Public IP address. I was trying :"IP NAT OUTSIDE SOURCE ... ... NO-ALIAS"but it is not working. I can connect from outside, with no problems.thanks,

Networking Gurus,Are the input/output rates for a given interface saved in a buffer ?What I am trying to achieve here is to generate a graph for a specific interface manually through excel without using MRTG/RRDTool.Any inputs would be very much appr...

I have a 3620 with a DS3 card in it (this is a production router) and would like to use the same DS3 card for a new 3845 router. Can someone tell me if this card is compatible with the new 3845 router? Thanks in advance, sK

Need advise/help pleaseIp 70.x.x.x = Local Users / Backup Email ipIp 69.x.x.x = Email / Local users Backup ipEverything seems to be working almost ok. The problem I am having is that the router defaults to the 70.x.x.x ip for Email. Here is part of...

I am installing MPLS service in a few of my locations and in process of configuring the routers. I am using cisco 1841's. I am a little unsure on how to configure BGP and configuring the serial interface for the MPLS..... Any ideas?

I have 2821 Router with 1 x WIC-1T and 1 x ADSL Card , My default route is my Internet Lease line but I want to send only port 80,8080 traffic through ADSL.Please help in configuring.I ahve already configuered Lease line , its working but now all tra...

Dear allI want to know is possible to channelize e1 into 30 channel and then assign each channel into one FXS port??

Hi,I have the attached network, I need to run ebgp with our ISP and perform load balancing on two 1G link Ethernet connections, how I can do that without looping problems, bear in you mind that our internal routing protocol is OSPF.Appreciate the exp...

Does anybody have an explaination or link that explains why ACL line entries will automatically get reordered? I'm trying to put remarks in the ACL, however the IOS seems to reorder things so the remarks aren't near their respective entry.I'm notici...

We've got an 8510 switch, which works OK for the most part, but some errors have been showing up in the log. They look like:.Apr 20 12:00:56.536: %ATM-3-ILMIOPTIPOLLFAIL: Internal error (3) in ILMI OPTIPOLL module.Apr 20 12:34:12.411: %ATM-4-ILMIKEEP...

i have a cisco 3845 router where port gi 0/0 is connected to internet and gi 0/1 is to lan. WCCP is enabled on port gi 0/0 redirecting out. now if i want to rate limit a single user or a group it does not work, but if i rate limit my proxy it works -...

Hi,I am trying to configure a site-to-site VPN tunnel between PIX and 2811 router. The authentication is thru MS CA where both the PIX and the router have already got their certificates.However, the vpn tunnel is not establishing and I get the follow...