Routing

Any ever seen a Cisco 3002 in Network extension mode allow https/ssh but deny telnet and snmp? I have it wide open and anyone can get to it. https://74.x.x.32/ username: admin password: ciscoCan anyone see what I have set wrong? I have 4.1 code and u...

Hello,I've got a VPN connected between my head office and a small remote office. All works except the remote office can't get onto the internet.I assume be default the internet traffic from the remote office will travel down the VPN. So I wondered ...

I have a 7206VXR that I'm using to terminate some PPPoE ADSL sessions. I have recently added another DS3+Serial interface to this unit for terminating some backhaul traffic from another carrier. The problem I'm having is that I'm intermittently lo...

need some advice.I know it wont be easy to get a job straight away.I need practical experience.Any website you recommend to use as a stimulator?I am using NETSIM, but i need something like a NETSIM PRO.Any other suggestion would help.Thanks you.

So, the ISP has agreed to replace our current 2MB x 2 Serial WAN links of xDSL technology to 4MB x2 links, probably MPLS based Ethernet offering from their side. The links are basically used for Internet based http/SMTP traffic.In the old scenario, w...

I need to enable SSH and disable telnet on my 2611 router. David Davis' article at TechRepublic.com says that SSH1 is available with IOS 12.1(3) but that a DES/3DES version of the IOS is required.1. Is 12.1(27) later than 12.1(3)? Yeah, I know thi...

Hopefully someone here can assist with a problem I've been having for a few months now.We run OSPF. On two of our routers, I would like to have the router analyze the traffic and decide which of two paths to take based on two things:1) The source IP...

Hello Experts,We are planning to remove all the "E2" Rotues from our Backbone of Large Scale Service Provider Network and would like to know what all the Measures to be taken care Prior / Post to the Activity.Please recommend with the List of Steps p...

Hi,I have Cisco 4500 router. It's processor memory is fully utilize, is there any way to release this memory except reload?Plz help

i have a situation, i want to enable the ip rtp compression betweeh hq and remote site's routers. here is the scenrio..a. HQ router ethernet interface is connected to satellite modem, and the remote site router is also connected thru ethernet to sate...

Hi all,We have 6513 as core rtrs in our infrastructure. The 'Show ip ospf' o/p showing the rtr ID as :192.168.101.1 on S1 and 192.168.101.2 on S2.But in our environment we are not using 192.168.101.0 subnet at all.Also, in the OSPF config , no rtr ID...

I need to know how to reset a 1760 router back to factory defaults. I've just inherited it and have downloaded the SDM configuration tool but still not managed to connect to it. I have managed to login using hyper terminal but that is as far as I hav...

Let's say I have one router with 10 T1 circuits and each T1 has an IP block of:200.200.1.1/24200.200.2.1/24200.200.3.1/24200.200.4.1/24......200.200.10.1/24Is there a way to setup the routing so the traffic that enter the router on a particular T1 al...

Hi Team,I have one shared MPLS DS3 circuit that having the Bandwidth of 9 Mbps that have been configured on our central site (Router-Cisco 3845). There are three remote sites which are connected to this central site through the MPLS circuit. All the ...