Routing

Hi,Can anybody send the configuration for converting a Router in to DHCP Server and how to configure the Scopes(for each vlan seprate subnets) in router? Pls help me.Thanks &Regards,Sham

Hello:My compaany has two locations. We have had them connected via ISDN. It has been working for the past 4 years, but all of the sudden (last Friday) the connection went down in the middle of the night. We have been troubleshooting for days with...

Hi. I have an oldie but a goodie... NY and Phil are interconnected via DS3. In Phil. the DS3 terminates on the SAME router as the INTERNET circuit!! In NY, there are two separate routers for redundant Internet links; both 45Mb. IF THE INTERNET TO...

A Router 3845 with a card "VWIC2-1MFT-T1/E1" requires of DSP to work as a RAS in a connection ISDN-PRI

Hi everyoneI am having an issue were the tracking state does not change to up after a simulated fail and the only way to change it to reachability up is by doing a reload. So any ideas what am i doign wrong? !ip sla 1icmp-echo 68.87.76.178 source-int...

Hy, sorry if i started a topic in a wrong place but i need a littel help. I don;t know if i can use a 2500 router for Voip. I want to installl a call manger express on a 2500. It is possible ? and if it is can you hel me with a cisco ios voice for a ...

As a general rule...BGP selects the shorts prefix match or the longest prefix match..And could you provide me with some documentation to support your answer..Thanks

hey guys, I need to find out the exact device behind our PIX and by comparing the mac address to the device we thought it was, we found out it was not it.The MAC address 001a.2fdd.42c7 is the exact device behind our PIX and I looked this up in the in...

Hi,I have a frame-relay interface which has this config:interface Serial0/1/0:0.500 point-to-point ip address 157.130.35.6 255.255.255.252 ip access-group 100 in frame-relay interface-dlci 500 crypto map CRX0do you know what command will give you ...

How do I limit the amount of bandwidth utilized on an interface on a 3825? We are looking at replacing our internet like with one that is a static instead of the burst feature we use today. To assist with the size we are thinking of trying to limit t...

Hi,we like to back up ios image from 7200 router using interface f0/0 which running vrf,which command we issue in copy disk0:running-config destination address[ ] ??? (can only reach tftp server via vrf)???Regards,

Hi,My name is Arik and i want to ask what is diffrance between NM and WIC except the size? (Hardware\Proccessor\Purpose)

Hi,We need to form two GRE tunnels on a primary and seconadry ip address of ethrenet of 1841 router. We have given primary IP address as say a.b.c.dand secondary ip as say p.q.r.s ( from different subnets ). Can we have tunnel interface 100 for prim...