Routing

Hi.I am trying to setup a following scenario:1. One PPPoE session between Cisco 800 and BRAS.2. 2x PVC between Cisco 800 and DSLAM.What I am trying to achieve is to bind ATM PVC Bundle with Dialer interface, but it can't find the right method. Explic...

Is it possible to use private keys to SSH Cisco routers from UNIX or Solaris PC?

Hi,I had a WAN PPP Link for two routers A & B and i promoted to FR via a Frame-Relay cloud . After this change I have noticed that several times per day the Adjacency between ROUTER_A & ROUTER_B is coming down for 2-3 seconds and then coming up agai...

Hi,I am connecting two ethernet switches together via CAT5e crossover, used for a 100BaseT network. The switches will physically sit ontop of each other.Obviously I want to keep the cable as short as possible, (20cm-30cm)I have spent hours & hours tr...

Hello everyone - I have a design question that involves a Cisco ASA firewalls (2 actually, one of them is for failover), a stack of 3750 switches and a Cisco 3845 router. I am a little confused about how the equipment should be connected for optimal ...

I have 2 subnets that i have setup on 2 interfaces. the 1st subnet (Company A) has internet access. the 2nd subnet (Company B) has no internet access or access to company A, from a computer on the on company b's subnet i am able to ping the firewall ...

Hi,I had three routers, R1, R2 & R3. R1 to R2 will run EIGRP. R1 to R3 will run OSPF. I managed to redistribute ospf to eigrp on R1. However, I failed to redistribute eigrp into ospf on R1. Hence, the R3 is not able to see eigrp subnets from R2.Conne...

Hi Guyshere is my diagramPBX--E1---Router1---E1---Router2--E1-PBXI set codec G729 for pbx calls to user more bandwidth.so should I do any configuration for passing this coded between R1 and R2?or the router r1 acts with them as data?

Are there any Cisco courses/books for the ACE

Hi to all Netpro users,I have this problem. Im using Policy Based routing on 2 ISP. As you see on the network diagram. im using flat network. dividing the 2 block of ip address. BLock 1 on ISP 2 and Block 1 on ISP1. At the same time im doing a vpn si...

Is cisco has a router (without fan) that operates between -40 degree centigrades to +80 deg. centigrades?

Hi everyoneI'm battling with a high CPU problem on a Cisco 3825 router (C3825-ADVIPSERVICESK9-M, Version 12.3(14)T7). I have identified packet marking (rate-limit with set-prec-transmit) as the culprit.When the rate-limiting is enabled, it is marking...

Hi,I have my router A connected to router B through ethernet.Router A also connected to router 1 through dialer.I am recieving Eigrp route 1.1.1.0 from router B as EXD with distance 170., also reciving route from router1 as distance 90,so this get in...