Routing

Hi allI just downloaded the SDM version 2.4 for my 827 4v router. upon executing the program, it says my router will not support the sdm version. Whats the correct workable version for this router and where can i download it?My IOS version is 12.3Tha...

HiCan you tell me which IOS version for Cisco 3640 uses less CPU when using CRTP compression?Thanks in Adance

Please in a simple way, how do you set up multilink and how is it different from using direct serial link?Thanks

Hello,if i configured 2 interfaces for my router:interface IP1: 192.168.1.1and i put this interface with SW interface IP: 10.10.10.10 at same vlan 10 ------ are the tow interface will see each other and can ping each one?thank you.

We have an OSPF neighbor and one router is sending duplicate hello/update messages. Also, can someone tell me if their is a show tech interpreter I would greatly appreciate it.thanksThis is the router sending duplicates:md01so14bbr01#show versionCisc...

Hi,I would like to serial data (V.35 and RS232) over a lease line, but can STUN or UDPTN use for the connection below?DTE -> V.35 cable -> WIC-2A/S -> Router 2801 -> WIC-1T -> lease line -> WIC-1T -> Router 2801 -> WIC-2A/S -> V.35 cable -> DTEIf not...

Hi All,I am facing a strange problem in my cisco 7505,7513&7206 router which are managed by cisco works.Thru cisco works i am unable to change the rate-limit variables. Even when i telnet to the device and did a no rate-limit command initially it doe...

Hi,Can anybody tell me how to configure the RARP proxy on a cisco switch.Regards,

Hi everyone, does anybody know if is it posible or a best practice to police traffic in a interface using rate-limit, when there is already also a service-policy applied to that interface?

We have the following QoS applied to a DS3 circuit out: class-map match-all Voice match ip dscp ef !!policy-map WAN-EDGE class Voice priority percent 33 class class-default fair-queue random-detect dscp-based policy-map shape class class...

I have a remote site with an ASA to the internet. It will have a default route pointing to that ASA. However, if the ASA (locally attached via a switch) dies, I want the remote site to learn a new default route from another site site with an ASA conn...

with the below config, dialer 3 triggers once the below command is invokedno backup interface dialer 3----------------------------------- interface Serial1/0/1 description Link to aaaaaaaaa bandwidth 128 backup interface Dialer3 ip address 10.1.1.1 2...

Where can I find information on what kind of reports one can see with an ASA with IPS. I know what you can see with MARS, but what can you see on an ASA with IPS?

Hey All;I want to know any tool which can identify the stetus of network equipments and there connectivity