Hi,We "sh tech-support" and find following: 6680/9000 BGP Router 5296/6000 BGP I/O 7508/9000 BGP ScannerWe had already disable the "BGP" and romve the "bgp process". Why does it appear in "show stacks"? Does it consume CPU loading and mem? how ...
Which of the following host addresses are members of networks that can be routed across the public Internet? (Choose three.)A. 212.193.48.254B. 192.168.23.252C. 198.234.12.95D. 172.16.223.125E. 172.64.12.29F. 10.172.13.65
I have a WIC-2T interface card on a 1841 router.Also there is a smart serial cable CAB-SS-V35MT. But the problem is that the modem end is X.21/v.11. Could some pls tell me as to how i can connect the smart serial from WIC-2T to the modem with X.21/v...
SCENARIO-router transmit (internet connection) on serial0-router receives (internet connection) on e0 (e0 is where the public ip resides)-the private network resides on e1 subnet.REQUIREMENT-restricts outgoing traffic only for http and mail-restricts...
Hi I have three higher end switch and connected like theseSwitch 1 ( VTP server ) -Switch 2 Client-Switch 3 client.Now i want to create vlan 100 in Switch 1, which is broadcast in swtich 2&3. My question1) I want to add port 0/2 of Switch 2 and Port ...
Hi, I have a problem when i enable QoS on Routers fas 0/1 interface. i am strucked up with this & i can't proceed further. below is the error i get when i enable the QoS of the commad on the fas 0/1 on Cisco 3845 Router.Rotuer-3845(config-if)#serv...
Imagine a scenario in which a router is connected to a local ethernet network, and to other routers on an internetwork. My question is regarding what is stored in the ARP cache on a host on the local ethernet.As I understand it entries in the ARP cac...
Hi Experts,I have a problem here,not too sure if it is the BRI Card problem. WHen I do a shut and un-shut on the card, the state will go to MULTIFRAME_ESTABLISHED from TEI_ASSIGNED when doing show isdn status.Is this due to the card problem?Thanks in...
Is there an advantage to one or the other? I know that you can view the whole policy easier using show policy-map int <interface>, but other than that, is there a fundamental difference from how the FRTS is being applied?
I have 2 routers connected with serial leased line. They are too far away each other. How can i change the ip addresses on both routers (network wan link) without going to that place and change it with the console but with telnet and do not loose con...
Hi,I have some problem with one of my 7609 router. I am having the IOS c6sup22-jk2sv-mz.121-27b.E2.bin in the router. Flex wan module WS-X6182-2PA is connected with it.When ever I am connecting E1 in module 3 the router is getting reloaded. But the s...
Hi,There is a tools "Output interpreter" tools can display the potential issue but it is for "register customer" only. The link is following:javascript:openChildWindow('https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.pl?style=small&ref_u...
I try to rate-limit with no burst. But, it seems the rate-limit command does not support a zero burst...The equation I was using for rate-limit normal burst= (rate-limit/8)*1.5exceed burst= normal burst * 2But now I have changed just to test, by lowe...
