Routing

Does a Catalyst 2950 switch have only one MAC address? Is this address associated with a network interface card? Is this MAC address associated with the IP address and default-gateway of the switch?

In 720x series router, we are having bandwidth point concept which controls the type of interface inserted into the router slots. In our network when we inserted an interface in the odd slot which increased the Bandwidth points beyond the advisable l...

I am looking at implementing E-mail, Fax & SMS channels to UCCE (ie IPCC Enterprise. I currently have Voice Recognition (Nuance) and IP IVR. I'm not sure if the Cisco E-mail Manager Option is the best solution when I still need to cater for Fax & SMS...

Hi, Would like to know if Packet over Sonet tested in Lab if so I have a config which is having issues:In back to back 7206 with NM-OC3-MM I have configured as follows :with IP address 10.1.1.1 and 10.1.1.2int pos4/0ip add 10.1.1.1 255.255.255.252p...

I just bought a used 2900XL.Dont know passwords, I tryed the Cisco passwords reset method. Doesnot work because there are no files in the flash directory.Help pleasedale

I just bought a used 2900XL.Dont know passwords, I tryed the Cisco passwords reset method. Doesnot work because there are no files in the flash directory.Help pleasedale

Guys i get this msg and when i type the passord its not getting in, is there any way to reset this password..

HiI wondered I read the the concept a lot of times, but I don't get it. Does someone could explain me detailed. Thanks a lot.Mike

Hi,I have three routers A,B and C all in area 0 connected to a switch. A and B routers require MD5 authentication where B and C doesnot require any authentication.Remember, all are in same subnet.How to configure ?Thanks,Vijaybabu

Hi, I would like to get an advise to choose a right router for my newly opening international Branch office. This time i dont want to go to a high-end router as this is the testing period.- There are below 10 users in the proposed BO- ADSL WAN connec...

Suppose Router A fast ethernet0/0 is connected to Router B fast ethernet 0/0If router A has below configurationRouterA#int fast ethernet 0/0ip ospf cost 20does command "ip ospf cost" is for outgoing purpose? which meanCost from routerA to RouterB fas...

Hello,I very often use the a couple of commands in the same order on our ios routers.Is there any possibility to create a macro or alias which runs then several commands.What I mean is to enter simply one alias or macro name on the cli which then run...

We have in our company 2 catalyst 4507R redanduncy(4 gigabit switch for each catalyst).The soft who permit to adminstrate it is Cisco Network Assistant version 4.0.I want to know if there is an another solution like ASDM for pix or SDM for router to ...

i replaced a server1 but used the same ip. used a different name. now i can only connect to it in my building. from switches at the other campuses, they resolve the name to the correct ip but cannot ping the ip. the router resolves and pings it fine...

hiwe are having more than 25 routers running ospf .and there are 4 different stub areas.namely 10,20,30 and 40.Routers connected to these areas are R1, R2 , R3 and R4 respectively. These are ABR. These routers are connected to other locations in stu...