Routing

Hello all, my name is Bernardo, and I'm a newbie to the Cisco world. I have been tasked with connecting our DR location with our Primary location over a WAN. Currently, the two locations are connected via a metro-e.I have two routers available to g...

Gentleman,I have the following scenario:PtoP link between main site and branch.(2620 and 1721 routers)two ASA at each site and IPSEC tunnel.Each site has its own internet access and would like to be able to route internet traffic if the main site or ...

I have Network ISP->Router 1811-> ASA 5505->WorkStationI want have access to internet with public ip serves on work station. Help me debug configs on router and firewall.Config router:interface FastEthernet0 description $ES_WAN$$FW_OUTSIDE$ ip addres...

Router Cisco 1750 supports WIC-4ESW interface?Router: CISCO 1750IOS : c1700-k9sy-mz.122-12

Hi all,There are ethernet switching port provided on netowk module and HWIC slot. What is the difference in performance/function between network modules and HWIC card. How should i choose? Thanks

Dear all,I have 5 routers titled router1, router2, router3, router4 , router5 connected as below:Router1 ---------Router2 --------- Router3------------Router4--------Router5No static route created in all routers. But just default route set on each ro...

Can anyone tell me what are the default values for the hold-down timers for RIP and IGRP ?Also am I right in saying that the router does not believe any new routes to the failed subnet until the hold-down timer expires, EXCEPT for :-(i) routes learne...

I have a Cisco 1721. After I Telnet into the router I use the router's Ping utility to ping both it's interfaces.The Private side averages 1-2 ms. However, the Public side averages from 60 to 80 ms or even higher. Any ideas?

Hi all,Below is my topo:R5--area1--R1--area0--R2---area0-R3Area 1 is a NSSA.R5 is an ASBR which advertises 100.0.0.0/8 and I am redistributing into ospf.R3 is also an ASBR which advertises 100.0.0.0/8 and I am redistributing into ospf.Since, R5 adve...

Hi,we have cisco 5400 with 16 PRI and connect to different providers. We check the CDR of 5400 and it does not include the PRI circuit and channel info. How do we enable it? please advise.Best regards

Hello dear guysi want to mark incoming traffic from my specific router to mark with high proirity quese for outgoing purposeany hint please

I've got a Cisco 2611 router running an IP-only GD release of 12.2(40). 48MB RAM. I've got a 384K frame-relay port attached to a WIC card; the PVC is 192K. Pertinant parts of 'show interface' are below. Do you think I have a queue problem, or a w...