Routing

Hi Can anybody explain me BGP synchronization in detail, or give me good document to interstand with proper explanation.-V

Hi,I am having issue to redistributing 2 vrf-lite routes into my LAN L3 switches.My topology is as below,PE router having two bgp peering with my CE, On CE, I having 2 separet routing tables, which I need forwarding to my 2 LAN swiches running EIGRP....

Dear sir,Iam having cisco catlyst 2960 48ttl switch in this i want to load HTML in this switch.because i want use this switch through webbrowser. but in this flash no html file plz tell me how can i load this html and its a folder.One more help plz g...

Hi Can anybody tell me , route-map future is working on dynagen sim, because as per my experiance, it only looks routing table. Please advice.-v

Dear All,I had on Router 1720,Unfortunatly my router can not login,it can log Rommon:my System Bootstrap, Version 12.0(3)T, i tred donwload new versionbut i can't donwload version 12.0.2T1(DF).it sho message like this:12.0(1)T, 12.0(1)T1, 12.0(2)T, 1...

Hi I have 2 routers connected via 2 serial links. To enable load balancing between the two i have configured EBGP using the loopback ips.routerAip loopback lo 1.1.1.1 255.255.255.255router bgp 64001neighbor 2.2.2.2 remote-as 64002neighbor 2.2.2.2 upd...

i have created a tunnel over a wan , the traffic on source tunnel is not matching traffic on dest tunnel,Can yoy plz help me in finding in this mismatch,plz also tell me how can i capture live data traffic on wan interface, any utility

Is it rigth config for cisco router 2811 which is using for PPPOE connection or any thing I miss?any help appricited.interface FastEthernet1 no ip address no ip mroute-cache duplex auto pppoe enable pppoe-client dial-pool-number 1 interface Dialer0 ...

HWIC is layer-II device i am using in 2811 i want to convert this to layer-III so i can assign ip address on ports. no Switchport cmd is also not working. i am trying to creat vlan but could not enter in vlan database. using 12.4 advance security IOS...

how to know the exact memory installed in my router say 7206vxr. flash, dram, nvram. are there any computation?thanks

Hi I noticed that some router models display the clockspeed detected when we use"sh controllerse serial" command.But not all routers display the clock speed detected. Any specific way to findout how much is the current clock speed on a serial port.Ap...

I am considering the Cisco 1800 series routers for my branch offices. Presently, there are Adtran Netvanta 3305 units in place. The primary reason for considering replacing them is the lack of traffic shaping features to rate limit non-critical tra...

Hi,I want to configure the following test scenario:The router remote1 (Cisco 2611) of a remote location is connected to a central router central1 (7206) via isdn ppp multilink connection.If central1 fails, remote1 should dial to central2 (a second 72...

I am using BGP4 on a private internet, I have to establish a 400 peers on a CISCO router (7k2 NPG1). I would like to know if that are afordable figures I just not?.