Routing

Hello All,I have two offices banglore and pune.Both are on diffrent subnets and i want that my banglore users when the login to my pune router then they should get the prompt so that they can share my ADS data while if pune user login the same they s...

HiMy customer have a multihomed BGP configuration (see attached router A), now my customer want to add a new EBGP link in another site to an upstream provider without having any internal IBGP connection to the main site of its AS10. In the new EBGP l...

Can the 7206 be used as a MPLS PE router? I don't think it is common but is it effective?

Does anybody know about IDB limit per platform running IOS 12.4T?RegardsStefano

What is the main raison for a multihomed costumer to apply outbound route filter to filter the BGP update from customer router to a service provider router ?A. To ensure that the return traffic in the customer network 'll be load balanced between the...

Hi,Can anyone tell me if there is a way to tell what traffic uses the default route?I need this information because I am in the middle of a migration project. I need to remove the default route at the end of the project because of security concerns, ...

Hi,Can any one help me in getting some documents which contains information about channelised e1 and its configuration.

Hi,We have two WAN links (E1 and 1M). how can we config load balancing? e.g. two packets go E1, one packet goes 1M. ThanksBest regards

I am configuring two 1811s (1811 and 1811W) and have run into the same problem on both. Configuration has started out with SDM, but debugging and "final" config is through the console.I have 4 private nets (192.168.1.1, .2,.3,.4) that are running on...

Whilst working on Live Labs on my CCNA course I notice sometimes '-- More --' appears when running the 'show running' command (and hitting spacebar then moves on to the next page of output). Sometimes the whole output is displayed all at once, ie. wi...

Hi All,I am setting up an internet T1 and have been told to use the ip unnumbered command as they do not provide /30 serial addresses. I also have to do nat behind this link. Normally I would put my ip nat inside on the ethernet int and the ip nat ...

Hi We ahve a 15 MB internet connection used for internet as well as for VPN users. I want to reserve 5 MB for the VPN concentrator so that our site to site VPN / VPN clients get atleast 5 MB.I have configured a class map statement to match ipsec and ...

I am pretty much a novice as far as router configuration goes. We have just purchased two Cisco 1841 routers with the T1 interface. I have them configured, but am trying to test the communication between the two routers before shipping the one to t...

Hi, I have customer who has recently installed a Cisco 877 on an ADSL MAX BT circuit. The problem is that they keep getting retrains every few hours. I believe that the router is training up at too high a speed and line errors or other line issues ar...

I have two WAN links that I would like to load balance traffic across using EIGRP but both links come in on a switch card and are separated using VLANS. I know with EIGRP its important to have the delay and bandwidth set to accomplish load balancing....