Routing

Hi Guys,What is the command on the router to check if any hardware has failed. For example fan.Tks

hello folks wondering if i could use this router as a frame-relay switch pick it up cheap on ebay

Dear all,I recently do a testing on the HSRP for router redundancy. In the configuration, I use a static route for the routing instated of using EIGRP or OSPF for the routing protocol.The problem is, I can achive router redundancy by using the OSPF a...

hi,i have a problem regarding eigrp.i have eigrp enabeld between two routers which are connected over frame-relay.since yesterday i have the problem that i always get the message "neighbor down - retry limit exceeded".i know that the problem is that ...

I have only DS0 channel and i want to carry that DS0 channel through the IP/MPLS network. As this is only the DS0 not full T1 so i dont want to west the bandwidth, so i am planning to have DS0 channel should be terminating to the FR or Serial interfa...

I have a cisco 2610 ios ver 12.0 with two serials. One Wan ip from the same provider.I would like to know how to configure my serial ports and bound them so I get 3mb.Thanks a lot.

I have a 2811 router with a four port etherswitch high speed WAN card and under normal operating conditions this works fine. However when there is a larger laod in the network I am seeing dropped TCP packets (and the usual retransmissions etc). The l...

Greetings - I could use an expert on this. We have a Win2003 network/WAN using a 256k VPN tunnel. The performance when trying to copy files and add/print is very poor. We had the WAN line tested, and had Microsoft look at the server.Our throughput se...

Attached are 2 files which are the configs for our 7204?s in NYC (old config and new config). Before we migrated to PIP(private ipm= MPLS) and BGP, we used access-list 10 to control which static routes defined in the 7204?s and our MSFC?s were allow...

Hi,What's the equivalent command in IOS for the PIX command 'static (inside,outside) PublicIP PrivIP netmask 255.255.255.255?This is the first time I'm doing this on router. I have tried the command:ip nat outside source static tcp PublicIP 25 Privat...

Hi all,We would like to connect an ISP (small DSL line) to a 6500 switch. We have 2 kinds of Catalysts and thus 2 possibilities:1) the old one where the Switch runs on CatOS and the MSFC runs on IOS (12.1(8a)E4)2) the new one runs on IOS 12.2(18)SXFP...

I need to know info regarding multicast ip ike 224.0.0.2 and 224.0.0.4 how to route to these ip and y they are really used kindly if some one can attach info regarding multicast address i will be thankfullas i tried ip route 224.0.0.2 255.255.255.255...

Hi Guys, My customer it is configuring the IP SLA 20 (for example) in the router 2600 with version 12.4(9) T1 and appear the message: % no memory left to create probles. I searched for bug, but, I did not find nothing. Somebody has some idea?Thank Yo...

If I have a multilink of 4 serial T1 interfaces how does traffic share across the circuits ?Can this be changed with CEF ? I am wondering if traffic would fill the T1's in sequential order or does it put packets across all four at once ? I may have o...