Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hi all,i'm setting up an inbound ACL on the gateway's WAN interface. i want to allow all GRE & PPTP traffic from my Win2k VPN peers to my Win2k VPN server, and deny other IP traffic to this server. i did the following: 10 permit tcp host remote_pe...

Hi,What could be the reason for the following Symptom.Interface Status:- Down.Interface Line protocol:- UPHas anyone experienced such type of problem? If yes please share.Thanks:Ajeet

Hi to all,I have some questions about LLQ on ATM PVCs.The config output is from the CPE (Cisco 878):controller DSL 0 mode atm line-term cpe line-mode 2-wire line-zero dsl-mode shdsl symmetric annex B line-rate autointerface ATM0 bandwidth 1536 no ip ...

Resolved! PAT ISSUE

HiI have two routers connected through Public carrier provided MPLS netwro.Both can ping on thier serial interfaces alongwith service provider end IPS. but failed to ping on each other local fast ethernet. The configuration of Router 'A' is here:inte...

Hi AllI need to Terminate fibre using a router,2800 ISR and was wondering if someone knows which modules does this.Thanks in AdvanceTau

tmailula by Level 1
  • 405 Views
  • 1 replies
  • 0 Helpful votes

Router 1841 doesn;t show temperature status when I run command sh env whereas 2800 is showing.The IOS is 12.4 on bothKindly suggest??Output:sh envFAN 1 Running sucessfullyILP Power Supply - Absent

tahseen12 by Level 1
  • 4062 Views
  • 5 replies
  • 0 Helpful votes

Hi,Cisco 877W ADSL Router causing errors below. This happens each time I do a 'show run'Is there a fix for this?*Mar 6 06:02:56.613: %SYS-3-CPUHOG: Task is running for (5000)msecs, more than(5000)msecs (10/6),process = Exec.-Traceback= 0x80132C74 0x...

I have got one Intranet server located at our Head office and the IP address is 10.49.13.7 and i have configured another backup server which is placed at a remote location and the IP is 192.168.10.5. I want to know how to configure cisco router to re...

I have hub and spoke topology. I tried to ping the local router interface then i am not able to ping but when i tried to ping the remote router interface then i am getting the reply from the remote router. so do i need to define the DLCI to the local...

dangal.43 by Level 1
  • 685 Views
  • 8 replies
  • 0 Helpful votes

*Mar 1 01:16:28.419: %LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel0, changed state to up*Mar 1 01:16:57.419: %TUN-5-RECURDOWN: Tunnel0 temporarily disabled due to recursive routing*Mar 1 01:16:58.419: %LINEPROTO-5-UPDOWN: Line protocol on...

HiMany documentation are stored in http://www.cisco.com/warp/public/104/1.htmllike example if i want to routing protocol ospf then go to the link.but if i first browse http://www.cisco.com/warp/public for to see the content then i can not get it. so ...

iqbalkhan by Level 1
  • 366 Views
  • 2 replies
  • 0 Helpful votes