Routing

Hi;I have a C1721 that I was trying to upgrade the IOS to allow for the new DST changes. Problem is, I added the new IOS, deleted the old IOS and rebooted the router thinking the bootstrap would find the new IOS and boot to it. Well, I keep getting t...

Just has my 7206 go down. Here is what was on the console %SYS-2-NOTQ: unqueue didn't find 0 in queue 62608688-Process= "<interrupt level>", ipl= 1-Traceback= 60488630 60484E28 6047A364 600E6638 6010EC20%SYS-2-BADSHARE: Bad refcount in retparticle, ...

I have a quick question what would you suggestion on a router. I want to run a bonded T1 but not sure what type of router I should get. I thought a 2800 series router would do the trick but I was told no. Basically it is going to be a 3 meg pipe

had a question about the recent NAM vulnerability advisory for the Cat 6000,6500s. I am running OS v7.6(5). Do I have to worry? Thanks for your help. -B

Hello Guys,I want to run a "debug ip packet detail acl#" on a CE router that has many VRFs attached to various subinterfaces of a GigE interface. Lets say I am only interested in the traffic that passes through g0/0.200 - vrf B but don't want to cau...

Hi,I would just like to ask how to detect an intermittent line. We are using 4 Fast Ethernet to connect two sites.The interface won't go to down/down state because all of our FastE interfaces are connected to the media converter of the provider. We h...

My situation is simple. I have two branch offices that need access to my servers at HQ. I have all four serial interfaces up/up at HQ and at both branches, but cannot get any traffic routed across the T1's. I need as much help as possible. After ...

We're having difficulty trying to bridge 2 7304 routers for exchanging control messages and at the same time apply some QoS on the voice traffic between them. Any help will be greatly appreciated.Consider the following scenario. We have a 7304 router...

I have a multilink established between 2 endpoints; each endpoint has 2 T1 point-to-points in the Multilink interface. If 1 of the T1s goes down does it take the Multilink interface down for that end point?

hi,i have a few questions regarding DoS attacks and CoPP.1. i have gone through the cisco control plane policing guide and there seem to be no hard and fast rules for deploying it. is there a one-conf-fits-all kinda solution to this? which ensures th...

Hi, My questions is as follows :- If we have two routers, R4 and R5 and have 2 connections to each other ... one link is through the FR cloud and the other is through HDLC encapsulation. My Q is that by using the bandwidth...

I'm throwing this question out there for an assignment I need to complete. I am to write a security plan for a ficticious company with dual T3s between their two sites (one housing a NOC facility). My question is what application could be supported o...

I apologize in advance if I can't word this question correctly.In real-world scenarios, how is the "Next-Hop" address's network propagated to the internal routers. Let's say that there is a transit AS that is multihomed to two separate AS's: 10 and ...