Routing

I've been the systems administrator here Since May. I'm hoping someone can help me as I often have a lot on my plate and cantg devote the time to learn cisco as much as Id like. Background: We have 2 ds3 connections (44Mbps) each coming into our ro...

Hi, Router Model: AS5400Card Type: as54-ct3-dfc (Channelized T3 Port)When I tried add channel-group in the T1 number 11. I received the following error "%Insufficient HDLC resources to create channel group". How I can resolve this issue.

Dear Experts,Recently we have added GRE Tunnel to our 7200 router. When pinging the tunnel interface (5000 byte packet ping above) it seems like there are packet drops. Moreover, File transfer trough the tunnel is very slow. I tried Pinging the physi...

Dear experts,one of my customer is having 3660 router it was a main router in thathaving wic12t nm cord.now the problem is router is hanging suddenly ping is getting request timed out and on thattime iam not able to go through console while restat on...

I have a 2801 Router with IOS ver: Cisco IOS Software, 2801 Software (C2801-SPSERVICESK9-M), Version 12.4(3d), RELEASE SOFTWARE (fc3). I want to use a WIC-1SHDSL_V3 but it doesn't work in slots 1, 2 and 3. The led status on card is always off. Is the...

Do any of teh cisco 800 ADSL routers support IPX?

Hi, I have a requirement for one of our services to be offered that Serial and Ethernet Interface should be included under a Single BVI. Essentially this is required to monitor the network as customer does not allow us to touch the CE. In the attac...

Hello!AS5300 does not NAT packets from not directly connetced networks.IOS (tm) 5300 Software (C5300-JK9S-M), Version 12.3(21), RELEASE SOFTWARE (fc2)

I configured two router as belowRouterA (stub area 1) --> RouterB (stub Area1 & Area0 )I haven't add default-information originate in RouterB but RouterA can learn a route like this, why it happen like this ?O*IA 0.0.0.0/0 [110/11] via 172.20.1.9, 00...

I have a 3750 switch, with 150MB internet coming into g1/0/1...i have 15 ports g1/0/2-15 that go out to customers, i want to put a policier on the ports to hold them at 10MB, my question is should i do a service-policy input or output here? i want to...

Hi, We know access-list 12 permit 192.89.55.0 255.255.255.0is invalid, because the wildcard is wrong. My problem is that the router did not give you any error message when type it in the router, instead it changed to access-list 12 permit 0.0.0.255 ...

I have a route-map set on interface and access-group ACL what router will do first route map trafic without looking at access-group acl or other way arround?

There is an IPSecVPN tunnel between 2 routers. On both sides there are subnets in use, and several are the same. :-(So there is a need for NATting through the tunnel.Part of the config:---ip nat pool Portugal1 10.35.1.10 10.35.1.254 netmask 255.255.2...

I've been troubleshooting this for hours and I just can't figure this one out. I have 3 7200vxr NPEG1 routers that each have a single ethernet connection to a 6500. VXR1 has it's gige interface sub-interfaced into vlan2,3 with dot1q encapsulation. ...