Routing

Hi Allcan someone tell me if I have infact deleted the IOS on my router. here is the output of the dir for both:Directory of flash:/ 1 -rw- 1680 <no date> startup-config8388608 bytes total (8386864 bytes free)router827#dir nv...

I have a DSL connection that is up and working (not the real address):IP Address 199.x.143.x.255.255.224Default Gateway 199.x.143.129We have purchased another block of addresses from the provider:199.99.x.73-78 255.x.255.248I have been instructed by ...

can anyone please explain that what is the defaul tunnel speed which is automatically set up by router, also any good documentation to read about tunnel traffic engineering. like bandwidth shaping and QoS

Hi Sir,I have a router whose LAN is an 802.1Q trunk terminating a few VLANs. It also has a DS3 WAN link. There's a requirement to bridge the VLANs to the DS3 link. Can it be done? Are there any disadvantages of doing this?Please advise.Thank you.B.Rg...

Hi all, could someone can help me with regards to the following:The situation: I have currently a Cisco 1841 router and approximately 20 PC?s and 12 RF hand held scanners.Both PC and scanners run on a 250K leased line. The server is sitting at anothe...

HiWe have a cisco 2600 and Nm-1ce1u module they are working fine and E1 link is up ,i use 1 timeslot and serial 1/0:0 to connect to another peer the peer ip address is 172.16.1.1 ,everything is fine and i have my connection from router cli but when ...

I have workstations on network x accessing servers on network y, for some reason a couple workstations on network x aren't able to access servers on network y and all workstations on network x are configured and installed exact same way. The weird th...

Hi,I was wondering if anyone could explain what is the operational difference between these two static routes:ip route <IP><Mask><nexthop>andip route <IP><Mask><interface><nexthop>Also is there a differences in how router processes them?Thanks,David

Hi,I have 1841 router. show version details are:Cisco IOS Software, 1841 Software (C1841-IPBASE-M), Version 12.3(11)T3, RELEASE SOFTWARE (fc4)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2005 by Cisco Systems, Inc.Compiled Tu...

Hello,We have a communications link with a customer. There is some sort of routing issue going on. I attached a diagram of everything to help out. As you can see, we cannot communicate with 10.90.5.1 (or anything else on the 10.90.5.x network for tha...

Can someone point me to a web-page what shows the Hardware requirements for Cisco IOS 12.2(31). I want to install it on my 7206VXR router but can not seem to find anything to tell me if it is going to be okay or not.Here is my Show Verion:Technology...

I'm in the middle of deploying a number of 2800 routers. For convenience I'd like to be able to copy some files into flash from a usb key I have. If I plug the key into the router and type dir I get the following error:%Error opening usbflash0:/ (I...

I have a strange problem with a route reflector advertising prefixes received from a route-reflector client back to the same rr-client. On the rr-client these prefixes can be seen by "debug bgp updates" but get "DENIED due to: ORIGINATOR is us".Is it...

Hi all,I am having the following need:Consider there three routers R1------area0-----R2-----area1-----R3Area1 is nsssa.In R3, I have the following configs:router ospf 100 redistribute static area 1 nssa network 10.1.1.0/24 area 1ip route 150.1.1.0...