Routing

I have 2 Areas running CLNS ISIS, say Area 1 and Area 2. Can the specific address in the database of area 1 router be seen at routers in area 2 ? or the routers in area 2 just see a prefix for the net in area 1 instead of the specific address ?

Hi Guys,Forgive me if this is the wrong forum.I have a 2MB P2P line between two offices, the link is provided by NTL and on each end I has aCisco2621XM router with a WIC interface connected to the media convertors.The problem i have is that most of t...

Here follows an abstract of a "show ip eigrp topology details" output, I guess the "stats" part at the end of some routes means "statistiscs", but what's the real meaning of each field and why they appear only on some (few) routes?P 172.16.37.0/24, 1...

I have two networks interconnected by the 4507 and the 3550. Unfortunately I can't make the PC's of both ends see each other (ping, etc.) But If I changed the gateway of the PC in the ABC-Network from 192.168.13.1 to 192.168.13.237 (VLAN1), then the...

I am reading the command reference right now, but it all seems very involved for what I want to do. I just want to prioritize bandwidth inbound (external IP) to a single machine/IP address. A server behind a 530 series firewall that hosts multiple ap...

-- 3750 --- - - (ds3)cat4500 --- ----- cat6500 - - (ds3) -- 3750 --- If I want to load balance between the two 3750 routers. Should I run cef in cat4500 or run c...

Hi There,A customer has asked us to configure a router for them that was previously used. However the previous engineer has configured a ROM Monitor password. Is there a proceedure to reset the ROM Monitor password? This is a Cisco 805 Router.Many Th...

hi!Dear allI have a BGP router learned a route through two way:one through eBGP,one through iBGP.For I preferred the iBGP path so I use route-map to set the eBGP route's origin to incomplete(the ORIGIN attribute has a higher priority in the decision ...

Microsoft netlogon communications fail across a NAT. Microsoft documents this issue at the following link:http://support.microsoft.com/default.aspx?scid=kb;en-us;172227Does Cisco NAT support the Nating of the Netbios header address in addition to th...

HiI have noticed that after configuring generic traffic shaping on a GRE tunnel on a 3660 with IOS 12.2(28a)- the show interface command returns wrong information - I have searched for bugs desribing this problem but haven't found anything. Has anyon...

Hi Friends...I am struggling with this type of ethernet interface on 3640 as I need it to support 100 Mb whereas I read somewhere on net that this type of hardware "AMD Presidio2" won't support 100 Mb. Max this type on interface would support is 10 M...

There are some voice network module and vic card version 1 for cisco 2600 and 3600. Do these voice cards work on 2800 and 3800?

sh versCisco Internetwork Operating System SoftwareIOS (tm) C2600 Software (C2600-IS-M), Version 12.2(11)T11, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2004 by cisco Systems, Inc.Compiled Wed 14-Apr-...

Hi,I was wondering if cisco devices, routers, asa etc... can sync with an external NTP server and then also play for NTP server for other devices?Regards,