Routing

Can we use both HSRP and primary link at the same instance for load sharing...

We have a Gigaman/MAN connection between two offices that is currently setup with (2) Layer 2 switches as endpoints. We are looking to change this to Layer 3 routing between sites. We will be using a Catalyst 3750 (IP Services IOS) and a Cat 4006 (...

Hi, There: Is there any ethernet module for 2851, so I could build layer 3 ethernet channel, and setup 2 ip address on it?Primary and secondary.Thx

Dear allwe have to restrict the network ie 10.116.125.0 network to block the server 10.100.7.###pls post some accesslist

Some cable providers provide multiple IP addresses with certain levels of internet service. Is it possible to have a router pull all the IP addresses available to it and put them in a pool so that machines behind it are not doing PAT?For example, if...

hi I have problem . i m uploading IOS via Ronmon but error are as follow.Frist status is :::System Bootstrap, Version 12.0(2)XD1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)Copyright (c) 1999 by cisco Systems, Inc.TAC:Home:SW:IOS:Specials for infoAS5300 ...

I have a WS-C6506-E switch. There is an IP connected to a particular VLAN. Iam getting Incomplete ARP entries for that IP. How do i find out to which port is it connected?

For dsl users, should the line protocol continue to go up/down ?I'm constantly getting up/down between several DSL modems connecting to a Cisco 7200 DSL router.The following settings are verified correct on Zoom ADSL modems: userpasswordvpivcimultipl...

hello,i want to know the TDM cross connects and how it works what is advantages of it? means basic guidence of it....regardsDevang

Well, Hello everybody.Probably the problem is simple but could you help me somehow with the next:I have DMZ behind PIX (192.168.2.0/24)I have network ahead PIX (192.168.224.0/24)The PIX is router of above networks. (CIDR)In 192.168.224.0 a have the s...

Hi, I'm trying to provide internet access to several locations through a single point. These locations connect via point to point links that aggregate on a 3rd party cisco router then connect to my ethernet interface. I also have another point to ...

Hello,I have question about DHCP server configuration on Cisco 1812 router. I know I can set multiple DNS servers in DHCP server configuration - for example Router(config-dhcp)# dns-server 1.1.1.1 2.2.2.2But I would like to have something like this f...

I would like to enquire on above mentioned product. As I believe it is mentioned this high speed wan interface card has 4 serial ports which can support maximum 8Mbits/sec EACH port. That would mean total of 32MBits/sec.1) Can I confirm if I can make...

Hi,I would like to enable WOL broadcasts at remote sites. The application is broadcasting 255.255.255.255 on UDP port 5000. I tried using IP Directed- Broadcast and tried appliying an access-list however the 4500 seems to allow the broadcast to propo...

Hi AllI have two seperate landing points on the same physical ethernetwork. I have 2 3845 routers as my WAN gateways.I have a 512k line going from Router A and another 512k line going from Router B landing at the same point at Router C, what is the b...