i have 4 1300 series bridges, want to connect to branch from H.O, planning to put 2 no's in H.O & 2 in branch. i want to use both of them, how can i use these 2 links? how can i achieve the load balance facility. In H.O & branch i'm using 3750 switch...
After a reboot of a 3640 router, there was a problem with the fastEthernet interface.When we checked the log, this is what we found%ALIGN-3-SPURIOUS: Spurious memory access made at 0x6021FE7C reading 0x10In a sh diag you see the following line:"Port ...
Hi Experts,Need a small clarification.I read some documents and ospf design guide which says that when we do internal summarisation we have to create a static route on ABR for that summarised address pointing to null0 interface otherwise it will be a...
Hi Folks,Someone can tell me how can achieve that. Imagine a router with a cpu high due a any problem or a debug running where the only solution would be a restart the router(in case debug). Is there any way to ensure that console and telnet will hav...
Guys,I have a very interesting question.I have multiple CE routers that are mutually redistributing between EIGRP and BGP. (multiple redist points in the network)Now the loop prevention route-maps I have does the followingA prefix originates from BGP...
I'm not sure where I'm dropping the ball on this one. This is my first cisco router. What I would like to do and what I was told this router would do is to transparently bridge our t-1 and ethernet. Here is my running-config so far:Current configurat...
Does anyone know how I can easily determine which I/O controller is installed in a 7200 via the IOS? We have several of them in different locations and I'd prefer to get into the router and see for myself, rather than call each office.
Have two 4506 with Sup IV (both brand new out of the box). Cant access console after they boot up. Using hyperterminal and 9600,1,8,N. Same behaviour on both boxes.Thought, something wrong with the cable or PC, so tried accessing two PIX firewalls an...
Hello there.Can anyone explain what late drop counter mean in show interface command ?Here is an example:core#sh interfaces serial 8/1/1:1Serial8/1/1:1 is up, line protocol is up Hardware is cxBus E1 Description: ISP uplink Internet address is xx....
in the following url: http://www.cisco.com/en/US/tech/tk713/tk730/technologies_configuration_example09186a0080093bf3.shtmlit is said that when making a PAD, from rtr 4 to rtr1, it will be successfull.however, in the end of the doc, we can see an inco...
I connected a 75ohm cable to PA-4E1G make a loopback test on 7507, but serial interface can't get up./ Is there any special configuration needed for PA-4E1G. Thank you !
Hi,I want to order the PA-4E1G/75 for my 7507.I wish that I can use the short cable for the PA-4E1G/75 card so that I find out two types cable CAB-E1-BNC and CAB-E1-BNC-3M. I don't know whether the CAB-E1-BNC-3M can be used to PA-4E1G/75. Becasue I o...
