Routing

I have an internet router->pix->layer 3 switch scenerio. The internet router, pix, and layer 3 switch are running OSPF so I can learn the WAN route. I also have EIGRP on the l3 switch for other corporate switches and sites. I tried to redistribute OS...

Hey guys, I'm new to IOS and Cisco but pretty good with the IPTables firewall that we are trying to replace. I have Cisco 1700 with a T1 card. I have configured the T1 to at least come up and I think I have the WAN side of the router configured corr...

Hello,I'm using MLP over FR on Cisco 2621XM IOS IP Voice 12.3(14)T1. It is a configuration based on this article: http://www.cisco.com/en/US/tech/tk652/tk701/technologies_configuration_example09186a0080101210.shtmlIn the startup config interface seri...

I am trying to configure a router for QOS NNI functionality. Because different providers honor markings differently I am trying to find something in common to mark packets with. If I set the qos-group how is it marking the packet and does it carrie...

We are adding a T1 circuit to run from Location A to Location B Currently Location A and B has a two Frame connections. Look Below:CurrentlyRouter A1 -------768FR---------- RouterB1 ip ospf cost 1000 HSRP priority 120Router A2 -------512FR-------...

I have 2610XM's with 12.3(6c)code. Trying to track down some strange usage using IP accounting. Going out from this router serial port I see packets addressed to 134.238.255.255 from IP's in the 134.238.x.x range that are different than the local LAN...

I create IPSce from my windows xp to cisco 831 router and it works. Now, I try to create a site to site vpn using Linksys BEFSX41 router and Cisco 831 router, but can't make it work. Can I creat a site to site vpn between these two routers? If yes, c...

Can anyone tell me if it is possible to bond a full T1 with a frac-T (12-Channels) using MPPP in a Cisco 1720 Router? In essence providing 2312K data BW. The other 12 channels would be utilized for voice services and split off prior to hitting the ...

I can't seem to find how many ds3s the 7204 supports?They have several different Network Processing Engines.With NPE225 NPE400 NPE-G1It is possible we will move our vpn connection to the 7204. That would enable us to do virtual firewalls wit...

Dear sir,I am Class A service provider.I am running BGP with same service provider on 2 of my branches.branch1 : ISP 1branch2 : ISP 1Suppose ISP 1 international bandwidth is down for branch1 only. But branch2 is not affected by it.So can you guide me...

cisco site says nm2ce1b is supported on cisco2610.but when i insert the card into 2610 , the router is hanging.could anyone tell me the minimum Flash and DRAM requirement for nm-2ce1b to be supported.i have 8Mb flash and 32MB ram.Regards

Dear all,I find that VWIC option only support E1, if I want to support T1 with G.703, any modules I can use?Thanksmak

It appears from the following text in a Cisco manual "Routes configured with the connected keyword affected by this redistribute command are the routes not specified by the network router configuration command." That the REDISTRIBUTE CONNECTED statem...