I am setting up a HSRP Concept with 1 Active and Other as Standby with both the router having Physical IP and 1 Logical IP. I would like to ask that, if Network Admin from remote end log in to Router with Logical IP address and Make some changes, in ...
Forum Posts
Most cisco documents say that the "IPV6_ACL-6-ACCESSLOGP" log will be logged as a result of ACL logging. But in my router, the logged message is "FMANFP-6-IPV6ACESSLOGP: R0/0: fman_fp_image: list~~" and also it does not record MAC address of source e...
Does eigrp exchange topology tables or routing tables?I'm ready multiple explanations and they contradict each other. When eigrp forms it's neighbor relationships does it exchange topology tables? Routing tables (RIB)?
Hi There, I am setting up my Cisco 1900 for home use. I am running into a problem though that I can't seem to solve. I have an inside interface gi0/1 with an ip of 192.168.60.1 and an outside interface gi0/0 with an ip of 73.xxx.xxx.xxx. The gi0/0 in...
Resolved! OSPF Routes
I have a LAN set up consisting of one Layer 3 SW and 5 Layer 2 switches. All is well and working fine, but on the layer 3 sw when I enter the "sh ip route" command I don't seen any OSPF routes in the routing table. All switches are connected via a vl...
Resolved! PBR OR ROUTE MAP ON ASA
Greetings community, I would like to set up routing on my ASA for about 80 subnets so that traffic to these subnets is routed to a specific interface. We would like to avoid using static routes so I need help in deciding the best alternative and als...
Hi I've been wrestling with this for a few weeks and would appreciate pointers, I haven't seen this type of configuration anywhere, but assume it's pretty standard. I started working on 2911 hardware with EHWIC VDSL card but due to faulty card (now ...
I am trying to get an imaging server (Microsoft WDS) to be able to image clients on a different subnet than the server. A few questions maybe you guys could help me with. 1. From my readings the L2 switches that the clients are connected to must have...
Hello guys, I'm working on a project to plan full redundancy for our client. There are going to be two data centers (primary and standby).Each DC will have MPLS connectivity to the client's locations, Internet connectivity, connectivity to different ...
Hello, all Although I read the forums frequently, this is my first time posting. Please know that I'm primarily a sysadmin and developer, not a network engineering specialist, and that I've worked much more with Cisco switches rather than routers. IO...
Is it possible to run ip unnumbered on ptp ethernet interfaces on Cat9K's and peer with eigrp? Links seem to peer, but no routes are advertised and eventually eigrp goodbyes are received. I have the following configuration: 9500-1:interface loopback...
Hello I have a situation in PBR, where there are two "set" statements in route-map as below, route-map ABCD permit 10 match ip address ACCESS_LIST1 set ip next-hop verify-availability 10.10.10.10 1 track 1 set interface Null0 I understand that firs...
Resolved! Open Shortest Path First (OSPF)
Hi i have this network which uses OSPFWhy packets take different routes sometimes?
i have a few off site cisco 1900 series whereby some application suddenly stopped working.eg Internet access is very slow or RDP to the site server fails.i can only RDP to the site router. no changes made to router config.i found this error on one of...
I have two ASR routers that handle my internet traffic. Each has one ISP (Comcast and Lumen). For some reason, the router I have connected to Lumen is adding a metric of 7800000 to all the routes it learns from Lumen. I have a fairly straight forward...
