Routing

Hi all, Within GNS3 I have succesfully created a DMVPN phase 3 topology with 1 HUB and 2 Spokes and all works well.I'm building a DMVPN topology with "real routers" but I get stuck.On the spoke there is no output with the "sh ip nhrp" command.At leas...

I am having trouble routing certain traffic through an IPSec connection and then out to the internet.Currently I have setup IPSec tunnels with another company. Computers from their side are given the an IP in the space of 10.64.0.0/17. Computers on m...

I have two 100 meg dedicated data links the connect corporate to our colo. I would like to configure them to be active/active and allow traffic to load balance between them. I am connecting a Cat 3850 stack to 2x nexus 9k. The links go from the Cat s...

HelloAt the moment I am trying to send services PPPoE to destination BRAS but the clients not connect. I checked of vc and tunnel up. This is sent through a 10G interface . The module is 7600-ES20-10G3CXL. Is there some limitation with the line card?...

I am trying to use a PBR on a Nexus 9504.  First problem is you can't have deny statements, so I think I have that fixed but it doesn't seem to be using the PBR.I have several layer 2 switches connecting to the Nexus.   All the vlan interfaces are on...

Hi allI have ASR1001-X router has EIGRP and BGP running .I created route-map for manage traffic redistribute from EIGRP to BGPhowever, I found out route map doesn't work when I use " match tag "Example #1I tag 1000 to all routes advertise from BGP to...

I have a Cisco 881 Router. Currently when it boots up then it goes to User Mode and prompts for a password (& not username) and after you enter password and then you type command: Enable then it again asks for password (& not username) and after typi...

I know this question is under the wrong topic but I am new to this community and I can't seem to find the right place to ask this question.I'm concerned about the new changes to the CCNA exam. I am currently doing an evening college course once a wee...

Hi all, I got CCNP Switch (300-115) in December 2017 and was studying for taking exams in September for CCNP Route (300-101).After the announcements for the new certifications, I see that having both Switch and Route on 24th February 2020 gives you "...

I have a Cisco 881 Router. Currently when it boots up then it goes to User Mode and prompts for a password (& not username) and after you enter password and then you type command: Enable then it again asks for password (& not username) and after typi...

Hi I'm looking to implement VLAN mapping for a proof of concept between two Cisco 6500. One is running old Catos & the other IOS.Config will look like this - does this look correct? 6500 CATOS Interface gi1/2/1set switchport mode trunkset trunk encap...