We are implementing our first sd-wan solution and are contemplating bench setting up the devices ahead of time if possible since that's what we normally do with new products, but our vmanage is going to be a cloud vmanage. Can we bench test these wit...
Forum Posts
Resolved! Traffic Policy - not working
I have problem with setting traffic policy. Im working on controllers version 18.4.1 and ISR1100 firmware is 16.10.2.My case: I have hub spoke topology set manually from custom controll policy with preference set on one DC to 400, second is 200. Both...
In Cisco SD-WAN we have feature called Cloud On-Ramp for SaaS/IaaS. Anyone aware of where I can find the YANG models for these features. I can see the APIs related to configuration of On-Ramp. But I could not find underlying YANG models used. Than...
Hi; I'm trying to build a lab for learning purpose and installed 19.1 controllers, starting with vManage. I cannot find any document regarding deploying certificates. I want to use my test Windows server as internal Root CA. I even didn't managed to ...
I have the below scenario.Cisco vEdge with 2 Internet links & both the links are used for DIA.Question:1 - Since 2 transport links are used, which link will be preferred by default. - Will it be load balancing both the internet link by default.-...
Would like to what is this CLI policy which SD-WAN supports & when to use it. ?Also what is the difference between Centralized policy & Localized policy
When enabling Logging of Sd-WAN cEdge devices to syslog servers, does the audit logs are also sent to the syslog server ?
hi,My vEdge is flapping, i don't know why, what root cause of this issue and how can i fix this?
Resolved! aaa tacacs issue
Hi, im having trouble connecting all SD-WAN components with my acs version 5.8.1.4-B.462 I think its configured alright. Got set up, authentication order tacacs->local, next add two acs servers, by IP, secret key, and vpn. %AAA-3-BADSERVERTYPEERROR:...
I was reading the below regarding OMP EMR Timer. Not able to understand it clearly. Can any one explain in simple terms ?
Would like to understand what is the difference between CLI or feature-based device template.I read the online documentation but not able to clearly understand the difference.If any one can explain what is the difference & which one to use it ?
Hi Guys, I have a doubt regarding network device failures. If a network device goes down, the up-links (incoming link and out going link) should be bridged and the network functions should work without any issues. How do we call this mechanism? Rega...
I have two site vEdge01 and 02 using vpn 1 to LAN .i already bring up vbond,vsmart,vedge to vmanage but i can't ping end to end using vpn 1 . this is my config :vpn 0dns 8.8.4.4 secondarydns 8.8.8.8 primaryinterface ge0/4ip address 86.10.252.72/24nat...
control-policy policy-name (in| out) Would like to understand the difference between IN & OUT for the control policy command in SD-WAN.I read Cisco documentation. But not able to understand clearly.
I have a question regarding the underlay networking of Cisco SD-WAN.Ex - I am using MPLS or Internet link as my underlay. OSPF is my service side routing protocol used for my DC & branch routing. To establish IPSec tunnel over the underlay either wit...
