What is the difference between Port Hopping & Port Offset ? From what I could understand, Port Offset gives a bigger range of ports that can be used. I might have misunderstood this so I need someone to explain this to me.
ello, trying to upgrade IOS on ISR4431 from Version 17.05.01a to 17.06.02 but vManage shows success but this is not on the router. There are older images but vManage does not acknowledge them as per attached image. Logs show not complete. How do I ge...
The SDWAN 20.4 Always Sandbox is not available anymore. Any idea when it will be available for testing the vManage REST API ?
ScenarioTwo CEdges connecting between two sites.Advertise each sites BGP routes between each other.When each CEdge receive routes from another, the routes stuck in INV U state.I am not sure what cause it.It was working fine before.I use both advertis...
I have a question about route redistribution from OMP to BGP. It appears that routes redistributed from OMP to BGP have their metric set to 1000 and local-pref set to 50. bgp routes-table vpn 201 10.100.106.0/24info 0nexthop 0.0.0.0metric 1000local...
Hi Sir,I am Beginner for SD-WAN, I want to learn and practice on this, Please, give pdf file and video clip to learn and practice. Thanks & RegardsDhananjay Kumar9899232293
Hi Please see the first below picture. I am trying to see DPI Aplication traffic flow after sending a big ping packet from device behind the vEdge, but it shows "No data to desplay". Did I miss some step? The second picture show some flow that I want...
Hello Community, I recently deployed active/standby set up for single router dual circuit where one circuit has slower speed and was meant to be a backup line incase primary failed. I made following two config changes to make it work and was curious...
Hi We have the below topology where ospf are configured at all devices. vEdge1 can see route 2.2.2.2, but R1 cannot see it. Is this normal? Can we let R1 see 2.2.2.2? Thank you 1.1.1.1-R1 ----vEdge1-----vSmart-----vEdge2-----R2-2.2.2.2
Hi Community, I have a topology where we have two Cisco IOS-XE SDWAN, in active/active mode.This SDWAN routers has ZBFW feature enabled, and all firewall rules are in inspect mode.The LAN interfaces of Both SDWAN Routers are connected to the same COR...
Hi all, I have Cisco ISR 1100-6G router and unable to access usb thumbdrive which has 1GB capacity with FAT format. Able to see it in file listing 'lsblk' and auto mount to /run/media/sda. But when access , it gave deny permission issue. Is there any...
Hi i have question regarding SD-WAN design, for the HQ router showing below in the picture should it be working as normal routers to connect the sites or have to be vEdge VPN0/VPN512 consideration the HQ right now is only connecting to other sites ...
Hello Everyone , Recently I have upgraded my Vmanage to version 2.6 for testing purposes. After the successful upgrade , I tried to login to Vmanage GUI with user "admin" , the system prompt me to change the admin password. As requested , I entered ...
I have a Cisco SD-WAN topology running version 20.3.2. Everything works fine, but the 'Monitor > Network' section isn't working reliably anymore for the past few days. Under the Monitor section for a selected vEdge device, if I go to WAN > TLOC (or ...
Hi!Who can explain me what is the meaning of column of "VS/VM" in cisco SD-WAN when one performs command "show sdwan control local-properties" and look at the table with tunnel interfaces.Screenshot is attacedAny ideas?
