Server Networking

Can anybody tell me if you can have a DLSw+ peer and IPSEC tunnel on the same router? We want to utilize DLSw+ on a branch router and use IPSEC across the WAN back to the corporate office?Has anybody configured this before?Any lessons learned?Recomen...

How many backup peers can I define? How can I manage a priority between them? In our network we have for routers - two for the Primary Data Center and two for the DR. Each remote site should have only one active peer at the time. We don't need load b...

I have a customer experiencing problems with their Microsoft Exchange and Outlook clients running across a newly installed ATM WAN. I have a 3 MB IMA circuit at the host as well as the remote. On a frequest basis the clients will get the requesting d...

Good Day:can i do configure dlsw with nat???I have a router 1760v. with ios Version 12.2(4)YB.thank you very muchh

I have a fiber in my campus enviroment that is being removed due to consturctiona and will not be replace. I am currently using IBM3044 (bus and tag to fiber conveters) channel extenders. The fiber is being replaced with a microwave connection. I hav...

Need some help.. I am new to MGX's and I want to understand the theory behind it and CLI because it’s so different then CISCO CLI. Plz help me if anyone know any URL on CISCO site, which can help me to understand this. Thanks Rits

I'm not sure which IOS to run on a router. I need IPSec 3DES and DLSw. What IOS do I need for a 3745?Also, what IOS do I need for a 1720, same requirements?Thanks

Hi,I've connected an OSA/2 Ethernet card to my 2950 switch. The Ethernet interface on the switch is defined as 10Mb FD and the OSA interface is also defined as 10Mb FD.The interfaces goes into a connected state and I can ping the OSA, but when I do a...

With the new IBM hosts z990, there are changes in IO subsystem (30 LPAR max, logical channel subsystem,...)I understand that the z990 LPAR number are now identified by 2 digits.We have 75xx CIP routers connected to our different zOS systems via Escon...

My task is to manage Cisco 2948G switch using NMS.I am supposed to use CISCO-STACK-MIB.I just need the following hierarchy info of Cisco 2948g switch.Please tell me the number of components in eachChassis |-->Slot |-->Module |-->PortAs per my knowled...

I just upgraded my C7206 router to IOS 12.1(21) recently. I configured Standby IP on the Fastethernet interface (note that there is no secondary router in place yet). Very frequent ICMP packets drop happens when I try to use the workstations to ping ...

I have two 3810v, both with 12-1(3a) software and I can not do a show running-config nor a write term command. I am seeing numerous buffer and memory failures, which usually points to an IOS issue. However, I am using this old of IOS to support VoHDL...

We have NCR 9800 mainframes, which are currently connected over a leased line...talking NCR proprietary protocol.We have a requirement now, to connect them over IP.I would like to know if the mainframe box supports any network controller cards to sup...