Switches - Small Business

All, As the subject specifies, I have a pair of devices on a local network that I would like to play nicely together. My problem: If the TS-459 is configured for standalone (No Link Aggregation), then I can access the NAS via Ping, web interface, NFS...

I've been tasked by 4 medical practices to move their servers into a colocation facility, connect their remote offices using high-speed fiber (10-100Mb) and still keep each practice separate.  They are sharing the colo and SAN to reduce their individ...

Where can I find information on using debug on the SGE2010P switches? The information in the admin and reference guides is extermely limited.

Hi,I have 3 Linksys switches installed on the rack.Model No: SRW2024PSERIAL1: K600015SERIAL2: JA00621SERIAL3: JA00476It is found that from the begining itself its 12th and 24th ports are not working.Please assist me to enable these ports in all switc...

Newbie question here. Can anyone advise please ?We have 2 separate networks here, 1 for data (192.168.0.x) and 1 for VOIP phones (192.168.3.x).I need them to both be connected to different ports on a switch (Cisco SG 300 10 port managed switch) which...

Hi,I've a network with 28 computers and 2 servers. Each server have a double Gbit port configured in Load Balancing & Fail Over.Now, I want to buy two Cisco's Switch SG 200-26 and I would know the best way to connect them and if it's possible to inte...

it's my first smart switch, but i've set up a million routers, so i'm not a complete n00b.the only change that survived power cycling is the change of default password that it forced me to do.what am i doing wrong, or is the box defect?

Hi all,I'm wondering if we are going to be seeing some better IPv6 support on these switches? Maybe even some static IPv6 routing? Thanks.

Hi!I recently got a new SD208p Switch and i have problem to use the PoE. I have a Cisco Aironet 1231 Accesspoint and I am using it with PoE on my ASA5505 but i does not start on the SD208p switch. I have tried to change the settings on the AP but no ...

HI;I have 2 SGE2010p switches connected in stack L3. I want to connect one another SGE2010p switch in the same location, but i'm wondering which solution could be better - attaching it in the stack or use it as stand alone L2 switch attached to the s...

Hello,   I just purchased a new SF-300 managed switch for the purpose of using it on the DMZ, so we can mirror the internet port and monitor traffic for my company.  I have set it up from the web interface to miror port 1 to port 2 and that's pretty ...

I have a Cisco SG300-20.I have read the documentation and cannot seem to locate the instructions for port forwarding.I need to forward TCP port 8088 to IP address 192.168.14.110 on the switch.How do I accomplish this?All assistance is appreciated.Tha...

Hi everybody,I am having an issue with LAG configuration on a Cisco SG300 52 switch. I have connected four Ge ports on the switch to the four NICs of a Dell R710 Server on which I installed Windows Server 2008 R2. Without LAG configured, these ports ...

I lost the rack brackets for my switch in a recent move. Where can I get more?

Hi:I'm planning to separate voice and data traffic with two vlans.  I have a COR switch catalyst 3750, a UC560 for VOIP with SIP trunk and SGE2000P as access switches.  The thing is i had configured VLAN1 (data vlan) and VLAN8 (voice vlan), i've crea...