Wireless - Small Business

Hi,I have Cisco Linksys Wireless-G Broadband Router WRT54G device at my site to establish PPTP tunnel with PPTP server. The tunnel gets established, but i can see the remote peer name like ePPTP instead which we have configured in that device.Firmwar...

I have two of these units setup as wireless bridging between two offices across a parking lot (about 25 yards, straight LOS, no obstruction). I am having a lot of problems with one or the other units suddenly stopping to respond. Looking around initi...

Hi all!We have more than 50 wap 200 access points. In our configuration we use wpa2-enterprise security mode with radius server. And use latest firmware(2.0.2.4). All works good, but after random time period (2 hours - one day) wifi access with wpa2-...

We have an existing Citrix Security Gateway and Web Interface that works fine within our wired network and is accessible via internet connections outside of the office -- all of our Citrix apps are accessible.  We recently installed a Cisco 2100 wire...

We are experiencing issues when we flashed from 2.0.2.1 firmware on our Cisco Small Business WAP4410n to the recently released 2.0.4.2. This is a brand new unit that we received. After flashing from 2.0.2.1, if the SSID Broadcast is set to "Disabled"...

Looking for a Cisco, low-cost power injector solution to push the WAP4410N. Network is all cat6 and the AP is 100ft away...Thanks, MarkI'm long on Cisco - I believe in the future...

A couple of questions about the AP541N:1. Does anyone finally have these installed and working properly, especially in a clustered environment?  I have read so many comments about slow performance, no performace, bad coverage, etc...  They sound like...

HiI just got 3 AP541, the reason for getting this was the dualband...but has anyone gotten this AP to actually give both 2.4 and 5 GHZ at the same time???I have in my other office a Asus RT56, it costs about 1/3 of the cisco and this supports both 5 ...

I just recently replaced an older linksys pre-N router with a RV 120W.  I thought this would be a good choice as a more professional router.  I installed this router last week and things seemed to be working normally for web browsing, though I was re...

Hi:I recently adquired an AP541N Version AP541N-K9-1.7(2) and found that it has telnet and ssh ports open and cannot find a way to block access through this ports.SSH and TELNET console are linux, it looks like a customized linux distro. I dont like ...

Need to boost signal coverage on an SA520W (even though it is very good, building floor is too clutterd and too darn big.Even using a 2nd unit to extend things may not get it all done; However, searching the site tells me there is an external aerial ...

I have a office that was converted from a older townhouse.  The building has 3 floors with the distant of each floor expands no more than about 60 - 75 feet from end to end of the building.  Not sure what's in the walls as the building is at least 20...

I have a cluster of AP54 IN. When  guests try to access  guest network, it should prompt with a webpage for a login name and password.Any clue?Many thanks.