Storage Networking

Hello,I am trying to setup LACP on the Nexus 5548UP 10 Gig switch on Port-channel 3. However, when I setup LACP, eth ports 7 and 8 (on Port-channel 3) go into either inactive or down state (as below). The 10 gig ports (7 and 8) are connected to a ser...

I have a customer with a WAN link 280 miles apart. Us (the Vendor) have an IP address on each side both on the same subnet on an isolated VLAN. Pings from site A to site B are around 8ms consistently with no drops.Pings from site B to site A vary f...

Hi,I have a problem with a MDS 9124 which has a duplex mismatch with a WS-C2960G-24. When setting both port to auto/auto the WS-C2960G-24 displays: Full-duplex, 100Mb/s while the MDS displays BW 100 Mbps half Duplex. This issue results in a duplex mi...

We noticed few SFP were missing on the switch model mds9519. Is there a way to check the switch logs to find when they were removed.

Hello,Where can I get fnic driver for xenserver citrix 6.0.2? I see enic driver on citrix.com but no fnic driver....Having VIC P81 FCoE card..need to update fnic driver to 1.5 which is 1.4 as inobx? Can i get 1.5 fnic driver for citrix xenserver 6.0....

QUESTIONS:1.) I would like to find out if enabling NPIV will affect any configuration on the Cisco directors or is it just a extra feature?2.) If Features are not available under licensing, as shown below; will I be able to use NPIV? FC_FEATURES_PKG ...

Hello,I have a Nex 5548 version 5.0(3)N1(1b)at this time release to configure FCoE was simply the steps of mapping VLAN to VANS, creating vfc and adding the vfc to the good vsan..now I'm stuck.I've my interface Eth in a PO. I bound the vfc to this po...

We ordered two 5548P and several 2000. They came with two types of SFPs. One is SFP-10G-SR, the other FET-10G. What is FET-10G used for? between 2000 FEX and computer servers?thanks,Han

Hi,I need a simple DCB or with Cisco wording FCoE pass through switch for a special test case.According to my current experience the Nexus does not pass through FIP VLAN Requests per default.All FCoE related features are disabled (again I do not need...

                   I'm don't some work on the switch and I save some information before I start - for simplicity just:sho flogi data >itMy team member comes in and does the same thing logged in to a different account and does the same thinghe getsThe...

Hi, Currently we are using version 5.0(3)N1(1c) in NEXUS 5548 Switch can i know any bugs in this version.I want to upgrade if any bugs in this version please let me know it's helpfull for me.Please let me know bug or vulnerability in this current ver...

OK so I just installed a B series chassis with two 6248 FI's connected to two seperate MDS 9124 FC switches.  The MDS switches have been in production for a while and have our SAN as well as other hosts connected to them.  My SAN is setup in passive ...

Dear Friends:Which is the maximum data bit rate for Fiber Channel over MPLS? Is it possible to reach the equivalent for 4Gbps Fiber Channel or 8Gbps?Could you bring me some additional documentation or reference?Thanks in advance.

Hi, I just like to know how we can do Boot LUN Masking for ESXi Host in nexus 5548 ,  that only use by specific host and other host cannot see it.