SANOS 3.2(3a) & FMS 3.2.(3a)One of the VSAN is displayed as inactive on FMS under the fabric -> isl tab, but it is not exactly inactive.From CLI "show vsan" show all vsans are active.Logs do not give any indiaction of any burps for that vsan. "show v...
Greetings,I took this over so its not my design...I have two Directors connected via two ISL's. There are two VSAN's across the two Directors that supposedly offers two "virtual" fabrics. One switch is at the primary data centre and the other is at...
Dear Friends,There are a pair of MDS 9509 switches whose management addresses are 172.16.2.197 and 172.16.2.198. When we try to manage these Devices through Cisco device manager, the first device opens up without any problem, but when the second 9509...
When I try to close Device Manager (MDS9509) I get the message: You may have CFS pending configuration. Do you want to continue. I get this message on all 4 switches in the fabric.Anyone who know how to fix this problem?
So I created a couple of flows using the Wizard in FM (3.3.1(c)) and they show up in Fabric Manager web client etc. How do I get rid of them. I don't need them anymore. All the doco I can find shows me how to run the wizard, nothing on how to remo...
I need to replace a mini gbic from a MDS-9124. I tried very hard to find the part number but it is not clear. There are 2 part numbers writen in the gbic, but I could not confirm any of it. The part numbers that is writen are DSSFP4GSW-4 and the othe...
Hi All,while upgrading the firmware on MDS9509 to 3.2, one of the blade (DS-X9016) failed to update the firmware. No error was reported.Later after looking at the logs, I found the reason was it is a Gen1 blade.Can I upgrade the fimware on a single b...
Dear all,In my environment, there are 2 x MDS 9513, EMC storage, Solaris, Linux and ESX 3.x hosts. Currently they are plugging in a same vsan. For some reason, I have to relocate all of them to another vsan. In my testing env, MDS9216, I found tha...
We already have four IVR Zones in our Zoneset and I need to add two new Zones. Should I edit the Zone database and add the two new Zones or run the Wizard and follow the idoit proof steps? I'm happy to add/remove devices in the non-IVR setup but just...
Is it possible to have different passwords for each of the devices connected into a Switch Fabric? In particular could one have separate and distinct passwords for each of the HBAs connected to a MDS 9000 Switch?John
Greetings,If I edit a zoneset on a switch that has other switches in the VSAN and they are connected via an ISL, what exactly happens when I activate the Zoneset? This is on a switch with the default zoneset propagation policy of activeZoneSet? Als...
