What is the difference between CON-PREM-6V2K9 vs CON-SNTP-6V2K9?
Forum Posts
Resolved! InterOP
We have a Cisco MDS 9513s that are running NX-OS 6.2(11c), which supports FICON. Is this NX-OS level compatible with the IBM DS8950? In other words, the latest FICON level of NX-OS is 8.4(1a) - are we required to upgrade the NX-OS code on the switch...
Can anyone suggest script to automate cisco MDS admin password reset?Thank you!
Hello, I want to connect tow brocade 6505 FC switch with a cisco mds 9148s. you will find bellow the architecture: When I try to configure them with interopabilty mode 2 I got this error: Isolated
Hello,We are in the process of migrating from Brocade 8510 to Cisco 9710 SAN switches. We will be using Rip and Replace method.There are documents online to migrate from Cisco to Brocade detailing high level steps, gotchas, caveats etc.Can someone po...
I tried to upgrade the firmware package of the S3260 by associating a chassis profile to it. The BMC was upgraded successfully but the CMC fails to upgrade after several hours of retries. Current version is 4.0.1a and the new version is 4.0.4h. Any i...
Hi all,I need to replace a Cisco MDS 9148 with a new Cisco MDS 9148S. I found the following documentation;MDS 9000 Chassis Backup, Restoration, and Replacement Configuration Example, which is very good. But I still have a few questions. The Cisco MDS...
Hi, I just installed a new Cisco MDS 9148 Switch and connected all our other devices using fiber to the switch, but for some reason none of the interfaces come up once the devices are connected. I made sure all of the interfaces are enabled and are a...
Hi, for admin MDS9221i we use Fabric Manager, buy we are unable to install it over Windows 10. The latest versión on download area is published on 2012. What happend, is Fabric Manage retired? Which software replace it?Thanx.
changing ssh port Is it possible? I want to know how to change the port. Thanks
Resolved! S3260 is not discovered on the 6332-16UP
we have a S3260 with a single server-single sioc. the 2 QSFP ports are connected to FI-A and FI-B but they are not detected. ports are orange in the UCSM page. ports of the FI are configured as server ports. any ideas?
Good morning, I am creating a standard cluster and i'm running into an error with the Create Cluster Validation portion Remote Node Validation Checks Executing validations on remote controller unable to get remote node connection information. The er...
Resolved! Smart zonning best practices
Hello! I cant find any best practices for smart zonning configuration. In my case I have 4 target ports from storage array in fabric and 20 initiator (server) ports.1.Should I create 4 smart zones per each target or I can add all targets into 1 smart...
Resolved! upgrade hyperflex esxi 6.5 to 6.7
Hi- Completely new to Hyperflex and I am looking into upgrading the ESXi 6.5 to 6.7 U3. vCenter was upgraded to v6.7U3 and that is up and running. Having not worked on Cisco Hyperflex before leads me to a lot of questions. Documentation I am going ov...
Resolved! After Password recover on an MDS 9148.
The final part of the procedure is to run "switch# copy running-config startup-config" however, my switch stays at "switch(boot)" and will not allow me to do a "copy running-config startup-config" how can I get to just the "switch"" prompt without do...
