Switches - Small Business

I have two VLANs, 10 and 40, with external ISC-DHCP servers in VLAN 10. I am successfully relaying DHCP across VLANs: a PC in VLAN 40 can request a DHCP lease, receive the offer, and accept the IP. My working configuration includes:ip dhcp relay addr...

In response to the bug described at: https://bst.cisco.com/quickview/bug/CSCwi16752The issue also occurs with the latest version 3.4.0.17. Switch model CBS350-12XS. The bug severity is set to Moderate, however, the CLI and GUI freeze for 10 minutes. ...

25-Jun-2015 08:44:45 %BRG_IGMP_QRR-W-DUPLICATE_IP: Duplicate IGMP Querier IP address 192.168.142.1 detected on VLAN 1. Remote MAC address is 34:a8:4e:0d:34:55. I am seeing this regularly on this SG300-28P switch.  These IP and MAC addresses belongs t...

How can I do my cisco 250 unmanaged?(Cisco Business 250 Series 250-48T-4G Switch 4)I have an issue to test.a software program, can't go trough the switch out, it blocks? If bypassing the switch direct to the router it works. 

Hi community,I'm a bit confused...I recently got a CBS350-24P-4X 1U managed switch, which comes with a wall-mount/rack-mount (I guess?) kit and I'm wondering, how I could manage to install this kit onto the device in order to align the rackmount-ears...

Hi all. Think I have posted my thread yesterday in the wrong area of the forum and should have been posted here instead.See my post here: https://community.cisco.com/t5/switching/expected-stack-behaviour-of-sg350x-switch/td-p/5205507 Regards: Elliott...

hello guysi want to setup switch SG300-28P in layer 3 mode. so that my below requirement can be fulfill. i try so many googles site, articles but no buddy can help me related to this. I want to create 4 VLAN (1,10,20,30) and ports assigned to every V...

Hi,   have here a nativ 2*SG550XG-8F8T stack. Today I received this messages.   It looks like only unit 2 was rebooting, but the unit 1 master did not respond to pings, at least 1-2 minutes at this time. Therefore our HA disk appliance (iSCSI & NFS) ...

Saludos, tengo un problema, tengo un Linksys SLM224P que no puedo pasar del login, les adjunto imágenes para ver si alguien sabe como arreglar esto, muchas gracias.Pantalla de logeoPantalla de logeo Se queda asíNo avanza y se queda así 

Hi, I have a CBS-350 series switch and want to check whether it supports the VTP protocol. Do you know how I can do that? Thanks,

Hi I have an SG500-28P that is behaving oddly. Factory Reset via button on the front took ages to respond, I have been told 10 seconds or above and it should flash all lights and reboot. It does not. Finally got it to reboot and now it goes through t...

Hi team  i want to check warranty of my Cisco device  so we can extend warranty with you and i have check with your tool warranty finder. This tool not provide correct information. So, please provide right tool for me so we can check ;warranty status...

hellouhave a weird one have here the said switch, a few of them...so i ve pluged in first, setup password, setup ip / route / hostnamesavedthan went into to the stack management, formed a stack (unit 1)did this on the second switch and when they boot...