Switches - Small Business

I installed my SG300-10 just after my router.  I hooked up the CAT5E cables and waited until I had internet.  Then I tried to login to 192.168.1.254.  I Get "This webpage is not available".  I looked at my router to see what is connected and I do not...

Hello, I am facing issue with CISCO SG300 switches. In my network we are using 1 no of 3850 switch as core switch and 5 no of SG300 for access layer. but when SG300 switches come in network (i.e when we give connectivity from 3850 to SG300 ) then ...

Hello, A new Cisco switch was purchased for an existing environment. The existing warehouse environment consists of Dell powerconnect 3448 switches and for a new construction area some 250 yards away, fiber was trenched and a cisco sf300-48 switch w...

I have a problem that is really bugging me. I have two Cisco SG300-20 switches. Both of them are configured in L3 mode. They have several VLAN's configured.When I reboot my switches some VLAN membership settings are lost! I have already saved the set...

I need to backup the configuration of my switch in a server file, but I want all those shows in a single file, does anyone knows a way to make it possible, I mean instead of doing this .... cli show run | redirect tftp://10.1.1.1/Backup-config_1.1...

I have a question about typing up an ACL and how to allow one website but block another with my sg300-52 switch. The website I want to block is youtube.com but I want to allow maps.google.com or anything else besides youtube. Now if I do a nslookup...

Hello, We are having issues powering Axis P1428-E cameras using SG110-24HP switch (24 ports, of which 12 are PoE ports, total PoE budget 100W). We tested and camera works OK in middle PoE ports (3, 4, 15, 16). Other PoE ports power a camera a for a f...

I have two SG500-52P and are both connected through a TRUNK port (native vlan 11 untagged, tagged vlans 4-8). I tried to reset and reconfigure both switches but the PCs connected to the access ports in the same VLAN but in different switches can't pi...

Hello All, I have several 100 SG300 series switches. With the latest update to 1.4.1.3I am having several problems. 1) anywhere from a few hours to a few days, the switches Web GUI (HTTP and HTTPS)stop working. Sometimes also ssh.  Sometimes the swit...

Hi All,I would like to know whether stacking with different stack port speeds is possible and supported. I own two SG500-52P switches which are already stacked using SFP-H10GB-CU1M modules.I know that between two SG500 switches the max speed can only...

Hello all , Can I make a stacking configuration between the 2 Cisco Small business SG300 52P to replicate the configuration and working as a one logical switch ?

I just downloaded LAN BASE WITH WEB BASED DEV MGR  c2960-lanbasek9-tar.122-55.SE10.tar and loaded it into the flash. Then pointed the boot to it in the subdirectory. dir flash:Directory of flash:/     2  -rwx        1980  Feb 28 1993 16:02:22 -08:00 ...

Hello, I have Cisco Small Business SF300 switch. CLI is more or less similar to IOS, but I can't seem to figure out how to PIPE the output of the command like in IOS: "show log | i fa48". I was wondering if the software on SF300 switches completely l...

Hii.. i am unable to access the subjected switch through console ,i have tried all the possible baud rate and different console cables as well . Please let me know is there any way to solve the issue . Regards , Jawhar.