Switches - Small Business

Hi,I have a SRW2048 connected back to a Cisco 6509 core switch.  For some reason, I cannot establish a gigabit connection with our computers.  Both Lenovo laptops and Dell desktops are failing; they always end up falling back and negotiating at 100/f...

Hi,I have a Linksys SRW224G4 with me. I have successfuly connected the switch with console.When i reboot the switch, it shows me something like this.------ Performing the Power-On Self Test (POST) ------UART Channel Loopback Test .......................

Hello, I have searched the forums but I have not found anything specific to what I am looking for.I am trying to figure out how to query an SRW switch for the full RFC1493 table. If I walk the  1.3.6.1.2.1.17.4.3.1 table, the only MAC addresses and p...

After unplugging, moving, then plugging back in my SLM2048 switch the system light flashes nonstop.  The switch was working perfectly before it was unplugged.  I have tried holding in the reset button for 10 seconds which causes all the ports to ligh...

I bought this switch in 2006. The Hardware Version is 00.03.10. Software: 1.0.0.50.I will be soon attaching a new Server 2008 to it with HP NIC's and Network Adapter Teaming Software.I know the HP teaming software automatically will use LACP (802.3ad...

We have a SFE2000 switch and we're having trouble configuring IGMP snooping.  It is enabled but we are still seeing multicast traffic on ports which have definitely not done an IGMP join - indicating something is not right.  The literature on the swi...

Hi,We have bought 1 of SLM2048 for our office to upgrade two old switches to one 1GB network. I wonder what is the reason that eveery now and then the trafic slows down to about 10 to 20 kB/s and I need to reboot the switch to get it working again. i...

I have a question about my Cisco Small Business Switch SRW2008.I know that this Switch should work with VRRP.But now my question: works this Switch with the specific Cisco Protocols GRBP or HRRP too?Thanks for your Answers.

Hello,I’m trying to configure a Linksys  SRW208P with VLAN and QoS to prioritize VoIP traffic.  I need a little  (a lot, really) of help with the strategy and setup.  The  elements:To the SRW208P switch we will connect 4x Cisco 7940G phones  and the ...

I have an SRW2008 switch, and it appears to be adding an extra byte at the end of some packets.  The value of the byte is always 0x0F.  Can someone tell me why this might happen, and how can I configure the switch to stop doing this?

i would be very happy if you could help me rectify this problem.my problem is when connect if goes on and off and sometimes am not able to connect even....i only see the login and password fields and when i log in i only seethe lego of cisco /linksys...

While I'm familiar with the Catalyst line of switches, I have not worked on the ESW models.  I'm looking for anyone that has done this successfully.  Can the native vlan be changed on both sides, is it possible to limit the vlans allowed across the t...