Switching

Hi Team,I recently purchased WS-C2960-24-S switch and I wanted to ask the following questions: 1. What is the difference between NVRAM, ROM, flash-simulated non-volatile and each additional memory type and how each memory type is defined on the syste...

Does 2960-X with LAN Base supports static route?

Atlas and Singlewire are blaming the 2960-X stating that it is blocking the multicast traffic and this is why the Atlas IPS-ZCM cannot register because the SLP packets are not reaching the Singlewire server. Already worked with Cisco TAC and they sta...

Hi All,I`ve setup many C2960 switches over the years but this one has me stumped.I`ve configured a brand-new out of the box Cisco C2960+24pc-l using the same procedure used on our other switches but when accessing the Web GUI the view that should sho...

Hello. I have a problem with C2960 switches after upgrading the firmware on c2960-lanbasek9-mz.150-2.SE7. 1. On the switch WS-C2960-24PC-L lost all copper ports, optics works. after downgrading to the previous firmware versions (including c2960-lanba...

Hi allI have a Questions from CRC issues.I heard CRC issue is a layer 1 trouble, so I changed optical cord, SFP and moved another port.so i grab a CRC issues in this time, I don't know what can i do troubleshooting for CRC issues.finally, I will upgr...

HiIam trying to update my WS-C2960-24TC-S IOS from version c2960-lanlitek9-mz.122-55.SE5.bin to higher version but new IOS is not able to boot .any body have a solution for that.Thank you

Hi Everybody, we have 1psc cisco ws-c2960-48tc-l switch, it come electrick but not see data on hyper therminal. power suply is ok no problem, befor elecktric have shutin in office then 3 min laters come in , but newer works was this issue , do have a...

Hello,I'm not an everyday networking guy - but have been taksed with getting these ready for an install. Our firm has some "templates" we use to help me along bu thtey are fo rthe model without the "S" at the end. Firmware needs to be at 12.2 (58) SE...

Hi,I've been advised by a third party vendor to put my catalyst 2960 poe switch into consumption mode. Is that possible with this model?Thanks,

Any suggestions??This is where I'm at:I'm using Secure CRT with a baud rate of 115220switch: set BAUD 115200switch: format flash:switch: copy xmodem: flash:c2960-lanbasek9-mz.150-2.SE6.binswitch: set BAUD 9600switch: boot flash:c2960-lanbasek9-mz.150...

Is there a copper 10Gbps SFP for the Catalyst 2960-S that is compatible for connecting to a 10GBase-T module on a Catalyst 4900M?I know there is some copper SFP's, but I don't know if they are 10GBase-T compatible. Also, with the limited distances, I...