Switching

I am trying to configure a 4331 with Call Manager Express and Cisco Unity Connection. We have an e series 140S balde server installed in the router. Initial config needs:- ◦ enable◦ configure terminal◦ interface ucse slot/port◦ imc ip address cimc-ip...

Hi,I have a 2960 Switch which has 2 ports dual T/SFP module. I want to use these two duals uplink ports for a category 6 coper cable.My problem is that on cisco, I have the GLC-T SFP module for that port to support cabling connection but it says only...

Hi All,I have problem to one of our device(IP Phone) connected to my switch(POE). Cable length is 150 meters and no option for fiber.Initially it was working fine for few days then the IP phone was off, on the switch interface there is err-disable. S...

Hi All,       I'm looking to implement AVB (IEEE 802.1AS, 802.1Qav, 802.1Qat and 802.1BA) on Cisco switches. I've searched on these forums, Cisco's website and google for any information there might be about AVB support on any Cisco switches. The clo...

Dear TeamI am a bit confuse with below terms while selecting product for one of my client. Please guide me a thorough knowledge of these terms or share the link which can guide me in a precise way.1) Switching Capacity with Stacking2) Forwarding rate...

Hi AllHaving a small HSRP related issue.Have 2 routers running HSRP with both having a route to the outside world configured via static routes.Comms to outside world works perfectly when all devices / interfaces are up. Primary router routes out no p...

We are setting up a new 9300 for our office. Do we need to install any licenses or should it be ready to go? Do we need to register this? why is it showing Eval mode? #sh license allSmart Licensing Status======================Smart Licensing is ENABL...

Hi Please helpI switched on my cisco switch. No problem with the switch boot process, but after boot I expected to see the host name that I gave the switch, but the host name is “ERMLog?>”tried my password but it did not work.I have never seen this i...

Cannot not putty into ISR4331 router via console port

Hi there. We have encountered a problem with the Catalyst 9500 SVL setup. We noted that the SVL and DAD could successfully be setup. However, after a reboot of the Standby 9500, the switch went in the Rommon Mode. We had to again issue the command : ...

Hi,Do we have a CLI or CLIs to display all packet drops because of forwarding (like L2/L3 related errors, ACL Drops etc) in the Catalyst Switch family. I am not looking at qos/queuing drops as such. Looking for more of forwarding drops.  Thanks. 

Hi everyone, I'm testing the cat9300 series on 16.12.x software. I applied a service-policy on a physical interface and am now testing the behavior of QOS. For ASR1k's I could use the command: show policy-map interface <interface> and it would show m...