Switching

Hello. Does a 3845 with the 4 port Etherswitch HWIC support NAT across the Etherswitch ports? For example, let's say I have 2 vlans (10 and 20) and assign ports 0 and 1 on the Etherswitch card to vlan 10. Ports 2 and 3 go to vlan 20. I create Lay...

Hi,We've lost password for console access to stacked C3750x switch(4 switches stacked).Can anyone recommed me best practice(with steps) for password recovery in this case? 

I'm new to Cisco Packet Tracer and would like to configure my web server. I believe I've done everything correctly, as pinging the web server from my PC works fine. However, when I try to access the web server from a PC's web browser, I get a "Reques...

Hi Community,Tengo 2 switch C9200L-24T-4X en stack, estos son sus datos:Version IOS:Switch Ports Model SW Version SW Image Mode------ ----- ----- ---------- ---------- ----* 1 28 C9200L-24T-4X 17.03.04b CAT9K_LITE_IOSXE INSTALL2 28 C9200L-24T-4X 17.0...

Hi Community,I have a WS-C4510R+E switch, I want to update the IOS.What would be the correct procedure for updating via USB and FTP?It is a single WS-C4510R+E switch, in that scenario how long would it take for the switch to fully load with the new I...

I am experiencing an issue with my Cisco Catalyst 2960 Series PoE-48 switch. The SYST and RPS lights are both solid amber, and I'm unable to access the console. This problem began after a power outage. In the past, when this occurred, I would simply ...

Hi Experts,we would like to prioritize a subnet traffic in Nexus 7K when refering to cisco docs its very confusing generally i see with dscp and cos value not sure about the steps as they are different default templatesgenerally on routers its prety ...

Hello networking demi-godsI am pretty new to the cisco configuration game but this should be a pretty easy setup. It's just 2 catalyst 48 port switches connected via an SFP fiber port on each switch.All the ports are access ports in vlan 1001 except ...

We are supported by DSL service and have a number of fixed IP addresses on which we run servers. In a couple of cases the servers are rarely accessed and therefore rarely transmit packets to the public network.In analyzing network traffic (since ther...

Our client configured a scheduled backup for the C9300-24P switch every week, but it backs up every minute. I cannot identify any issues with the configuration. Has anyone else experienced the same? The firmware version is 16.12.4. ###Configuraiton #...