Switching

may i know the command to configure a local username with an encrypted password and EXEC mode user privileges? 

After enabling PIM on c3850, hosts beyond its L3 EtherChannel peer (c7200) were not reachable anymore via EIGRP, although EIGRP route was looking ok.     c3850 (EIGRP A10) ==L3 EtherChan*==c7200(EIRGP AS10).... *Mode ON - only supported mode at c7200...

  Hello All,   I have a query Regarding router model ASR-920-12CZ-A  there are 12*1G ports first 6 ports are enabled by default and the last 6 ports (6 AMS Ports) are licensed ports.  I will enable the last 6 ports using license but my query is can i...

Hello,   I have one Cisco 6500 with SUP720 and i am trying to "lock" the rommon with the 'no service password-recovery' command. This command is not available in the latest IOS (151-2.SY11). Is there any alternative for this command or am i miss some...

Hi   I just wanted to check if there is a certain way that the stackpower cables need to be connected between 2 switches in a stack. I currently have a stack whereby the top stackpower port on switch 1 is connected to the top stackpower port on switc...

I’m trying to set up a pair of 1542D access points and I cannot get access to the configuration. Since both are behaving identically I assume it’s likely something I’ve missed in the, difficult to find, documentation. I’m using the “Cisco Wireless Co...

Hello,   I have a branch site set up with 3 2960x stacked and a 4451 router.  My default gateway for voice and data is on the router with a dhcp pool set up for voice and a ip helper address for data.  When I plug a laptop in I get this at first:    ...

bonjours  j ai une question j ai achete un routeur cisco 887VA-k9  , je le configuré avec la configuration ci-dessous si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + mon pc porta...

The Nexus 5548 switch when reloaded promptsloader>I read a little on it and first step was to extract kickstart using TFTP.I used my workstation to configure tftp server.But i cannot ping the mgmt ip of Nexus from the workstation.My workstation is wi...

Hi,I have stack switches, both are Cat3750. After I stacked it, I have the following error:Switch# Role Mac Address Priority State -------------------------------------------------------- 1 Slave 0000.0000.0000 0 P...

Hi, Any one help me out by sharing your knowledge on below questions.1.What is SDM and what is its functions.2.Is this used in swithces.

Hi All Can anyone tell me what is the recommended standard for applying QOS for VC systems, I have always seen EF for voice and AF41 for video, however I see people talking about voice and video both using EF in the priority queue. What are most peop...