Switching

I currently have a WS-C3560-24PS with SW Version 12.1(19)EA1d. The lowest version I can find on Cisco is 12.2(25)SE but the minimum IOS version needed for the upgrade is 12.2(18)SE. I am unable to find 12.2(18)SE. Any help would be greatly appreciate...

Hello, I have the need to send the logs from Cisco Switch to Syslog Server. I would like use kibana. Somebody used kibana with Cisco IOS before? Best regards,

I have an ASA that is solely being used to attach to AZURE's VPN If i attach to the inside network and use 10.0.0.13 as the gateway i can get onto the vpn network.  I'm trying to add this to our core network but the OSPF routes are not being showing ...

Does IOS on catalyst switch support LDAP authentication for CLI admin (exec) login ? I've checked numerous configuration guides, but couldn't find a clear answer. I see Radius is supported. Thanks!

Hi, I need help, recently in one router in our company the following issue occurred: %DUAL-3-INTERNAL: EIGRP-IPv4 I found information that this is software issue and IOS should be updated, can anyone advice what to do? Thanks in advance.

Hello, Can I edit a port-channel description for a aggregation layer switch (N3K) without causing any outage? Thanks.

If I have a provisionned switch in a stack that is NOT PRESENT (either from pre-configuration or due to switch failure), what will happen if I then add a brand-new out-of-the-box switch of the matching type to the stack?  Assuming the master is #1, a...

Hi guys;      One of a vPC pair of Nexus 5K turned off by apparently a hardware/power failure. We recieved the RMA. One question: in order to reestablished the vPC new pair member, the configuration of the failed Nexus must be applied to the new sw...

, Hi, I am getting the duplicate error  , so  entered the following command  . "ip device tracking probe delay 10". It did not solve the problem .So where should i enter the command  ,on distribution or access . ? The connection between Dist and acc...

Based on the image, is it possible to monitor the traffic to and from 6500?

Cisco 3750 swtiches. Core switch has ip routing enabled. I have a couple of sorenson VRS devices that cannot connect to the network. At first I thought it was a dhcp issue. I gave it a static IP address and still no go. Thinking it was port security ...

Hello, I have two NEXUS 5548 switches connected to our two core 6506's which are running VSS. NOTE: The 5K's are not running VSS The NEXUS' are connected to SAN gear and NEXUS 2K's using FEX connectors on the back side and are using HSRP on each VLAN...