Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Get 20% off switches when you combine Cisco solutions

 
Labels

Forum Posts

QoS

Hi, we have ME-3400-24FS-A series switch. It's uplink g0/1 is connected to other ME-3400-24FS-A. Clients are connected to f0/1-24 On almost all interfaces i see output drops, for example 1#sh policy-map int f0/12 Class-map: class-default (match-any) ...

eXPlosion by Level 1
  • 917 Views
  • 11 replies
  • 0 Helpful votes

In terms of using 'mls qos trust dscp' over 'mls qos trust cos', are there any specific rules that dictate where to use one over the other? So for example, is it simply a case of it depends on the switch capability, i.e. a L2 switch would only be abl...

Hello. i have a question about EIGRP. there are two EIGRP processes that run and two equal paths are learned, one by each EIGRP process. which routes get installed to routing table? how can i control that process? Aleksey.

Hello, what is wrong : Nexus1 (5548) vpc domain 1 role priority 4098 system-priority 2000 peer-keepalive destination 10.100.2.13 source 10.100.2.12 delay restore 150 auto-recovery ... interface Port-channel1 swithc mode trunk switchpo trunk nati...

Hello Friends, I'm new to Cisco VSS technology. I worked on HP IRF technology which quite similar to Cisco VSS (hoping so :)) I have a query here, does both switch in VSS accept and forward traffic means can work as active-active. Ashish.

Hello, I have a switch cisco WS-CBS3012-IBM-I attached to a Cisco 6500 through an etherchannel connection. This is the configuration in the etherchannel ports of the cisco WS-CBS3012-IBM-I: interface GigabitEthernet0/15 description FEC_4_Con_H-463...