Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello, Cisco Community!I’m really happy to share that I’ll be hosting the Cisco Community Lab Series, a brand-new hands-on learning journey designed to help you build practical networking skills step by step.Every Thursday at 8 PM EST, I’ll post a ne...

Hi there, Just looking at the port-channel config on our 3850 - example below... I'm just wondering why, on the interfaces that are members of the 1st port channel I see the allowed VLANS, but on the interfaces for the 2nd port channel I do not?  Do ...

jbrit1969 by Level 1
  • 13052 Views
  • 8 replies
  • 0 Helpful votes

Hi allI ran into a problem with VIP for high availability on Blue Coat ProxySG. Both ProxySG send multicast packets to advise the other ProxySG that it is up and the priority is contained in the multicast packet, along with the IP address of the VIP ...

Hello everyone, I actually have two Cisco WS-C4503-E in VSS mode. I need to upgrade those chassis from 4503-E to 4506-E using the same SUP 7-E and linecards as I'm using now. I've made some research on Cisco's forum and I've found this :  Asymmetric...

Dear, I have Cisco 6509 switch as a CORE of LAN. I am facing the issue as under: Whenever I reloaded the switch either reload command  or by powering on and off, It goes into ROMMON mode. (IOS is not loaded). In rommom mode after issuing the "boot" ...

Hello all, Can any one please help with interface errors troubleshooting ? when a show interface is perfomed on a switch, it shows a lot of error kinds (CRC,frame, overrun,.........). I was wondering wich ones are really blocking (once it's seen, act...

Marc_AMI1 by Level 1
  • 908 Views
  • 7 replies
  • 0 Helpful votes

Hello all, Can any one please help with interface errors troubleshooting ? when a show interface is perfomed on a switch, it shows a lot of error kinds (CRC,frame, overrun,.........). I was wondering wich ones are really blocking (once it's seen, act...

Marc_AMI1 by Level 1
  • 265 Views
  • 1 replies
  • 0 Helpful votes

Hello all, Can any one please help with interface errors troubleshooting ? when a show interface is perfomed on a switch, it shows a lot of error kinds (CRC,frame, overrun,.........). I was wondering wich ones are really blocking (once it's seen, act...

Marc_AMI1 by Level 1
  • 321 Views
  • 1 replies
  • 0 Helpful votes