Switching

Hi all We have a an MPLS connection to one of our sites, we can send large pings to any windows server,  apart from one of the hpux servers, we can send pings of size 1372 bytes to it but no more, if we try larger they fail. Would this be an issue on...

Hi All, I have a query. Can i create a switched port and a routed port in same port-channel interface ? In the scenario attached, a port-channel (PO 11) is created between ASA and Nexus. There is a load-balancer attached to Nexus. I want port-channel...

Hi everybody... I hope are you well doing  I have a printer and I want change IP from dhcp to static, but first I want to know IP address available to use ..How to make scan IP addresses don't use it for any person in my company ....  

Hi folks, I have a little design question in regards to Catalyst 650X VSS VS4O (quad supervisors) in regards to the dual active detection.I have seen that the recommendation is to use ePAgP utilizing an access switch as well as doing a separate dual ...

Hey folks, undoubtedly stupid question but I'm failing badly at RTFM. Have a fairly typical scenario where Cisco is remapping COS 5 to DSCP 40, when of course we're looking for DSCP 46.  In the 3750/6500/etc mls configuration, it's no big deal: mls ...

Hi,  I understand standard packet delivery process host-to-host through the router or a switch but following question puzzles me. HOST A (192.168.0.1) ------->HOST B (192.168.0.2) ------->HOST C (192.168.0.3) ------->HOST D(192.168.0.4)  Question:...

Hello, Everyone knows this standard campus Layer 2 loop free design (attached). Why the layer 3 interlink between distribution switches is needed ? Can anyone explain this.. Thanks

Hello, A vulnerability scan shows that SSL version 2 and 3 protocols have been detected on a couple of my Cisco Catalyst 3560 switches.  What command should I use to disable these? Thanks, Tom

I have a new cisco 2960 switch but when I connect to it using teraterm it just given me a blank screen. I can use the same laptop on other switches that were donated to us but not on any of the new ones. I tried basic setup but only the Main LED ligh...

Hi guys! First post here... I was wondering if any of you could help me out a litte. I'm getting a fiber connection in about a month and I plan on using my own equipment instead of the ISP equipment. I have a 3845 router and a 4948 L3 switch. My IS...

Hello Community. I have a Nexus 7009 with SUP2 and F248XP-25E running on NX-OS 6.2.14. I tried to configure Netflow and activate it on a SVI; see config bellow. When activating this on a Interface VLAN3192 I receive the following message: N7K-2(con...

Hi i have C3900 series router . currently we have configured router on stick on it hence the switch is not supporting for routing . currently we have only one interface connected with switch , we need to connect redundant interface . so we plan to co...

Hi all, Scenario attached. 1. Can i bundle 4 links (10G) from N5K-A and 4 links (10G) from N5K-B and bundle into a single port-channel group ? 2. Can i bundle 4 links (10G) from ASA-A and 4 links (10G) from ASA-B and bundle into a single port-channel...