Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello, Cisco Community!I’m really happy to share that I’ll be hosting the Cisco Community Lab Series, a brand-new hands-on learning journey designed to help you build practical networking skills step by step.Every Thursday at 8 PM EST, I’ll post a ne...

I have a Cisco ASA5505 setup as follows:Internet -> (Dynamic IP) Cisco ASA5505(5 Routable IPs) -> Draytek (Single routable IP) - 172.16.0.0/19                                                                                           -> Draytek (Singl...

SW1#sh spanning-tree vlan 3VLAN0003  Spanning tree enabled protocol ieee  Root ID    Priority    8195             Address     dc7b.9489.cf00             Cost        3             Port        56 (Port-channel1)             Hello Time   2 sec  Max Age ...

Hi , I've searched the internet and i could not found a clear explanation on the difference between ip nat inside and out side: IN my case out side does not mean internet or public : what i know so far, the ip nat inside do routing first and then tra...

Hi all,   From wiki The cabling layout used to link devices is the physical topology of the network. The logical topology in contrast, is the way that the signals act on the network media, or the way that the data passes through the network from o...

SJ K by Level 5
  • 380 Views
  • 1 replies
  • 0 Helpful votes

one of Our client has MPLS Network Connection in Saudi Arabia, the MPLS line is 1 MBps.we are providing them 52 IP Cameras (3 Megapixel), it uses 60 Terabyte of Storage for 24 Hrs 30 Days Recording, and the client needs all the recorded data should b...

A quick rundown on the problem. I had a user plug a switch into another switch configured with BPDU guard and the port shut down. They plugged their switch into another port also configured with BPDU guard and it let the switch connect. A little baff...

jnesbitt1 by Level 1
  • 1533 Views
  • 3 replies
  • 0 Helpful votes

Hi there, I have a question regarding the below config:=================================class-map match-any cm-prec-1-outmatch ip precedence 1class-map match-any cm-prec-0-outmatch ip precedence 0class-map match-any cm-prec-3-outmatch ip precedence 3...

Ok. I have been racking my brain out on this with no luck. Could really use some help in fixing itSo here is my issue. I have 2 different VPNs and both are able to be connect to. I have split tunneling enabled and that works. But when I am connect to...

JB

Hello Team,Please, what is the best way to renew my CCNA and CCNP Certification?Considering doing CCNA Security; but does this renew both certifications I already have?Kindly assist with this as I don't want any of both certifications I already have ...

Hi all, I am reading and testing on VTP and in order for VTP work, trunk links must be setup between switches.So i am thinking, if VTP is setup, it means that every switch (client) will have the same VLAN setup as the Server. q1) With VTP pruning, it...

SJ K by Level 5
  • 2368 Views
  • 4 replies
  • 0 Helpful votes

DearsI get the below from the show environment output I want to proof that the below output temperature is normal for the asic can anybody route me to the proper document for proof.switch 1 module 5:  switch 1 module 5 power-output-fail: OK  switch 1...

adamgibs7 by Level 6
  • 709 Views
  • 1 replies
  • 0 Helpful votes