Switching

I'm setting up a montitor session on a NEXUS 7K as below.we are receiving in 150M of data and 0 data going out port 9/25.but port 4/24 shows 300M to the span port?Am I doing something wrong here or is that normal?monitor session 10      no shutdown  ...

Hi ,Our earlier setup was broadband connection terminating on the RV042 V01 device and we had VPN tunnel to hub sites. Recently we have purchased MPLS connection at all of our sites and trying to migrate to MPLS cloud. I am facing couple of issues to...

Hi All ,Enclosed file has network connectivity diagram.1. L3 vlan's ie 2,3,4,5 and 6 are configured on ACC-CR1 and ACC-CR2. 2.Trunk is configured between Core switches ( CR1 and CR2) and access switches .VTP mode is transparent on all switches.L2 vla...

Hi -Can someone help me getting started (if at all possible...) with enabling controll of used bandwidth at a "per-user"-level.I wonder if it possible to do this dynamicly with respect to the overall demand from other users.I've searching a lot, but ...

G'day Guys,Scenario is that VSS is established between two 6500 with single SUP in each chassis but each chassis located in different DC and VSL is established via 10Gig link. My question is that for the following dual active detection mechanism, can...

Dear All, Can anyone help me out in preparing a Health Check Report for the above mentioned Cisco switches.your quick response will be appreciated...As i have to submit it by today, the main points what they need is Bandwidth utilization on the inter...

I have a device attached to an RS232 port of 2901 ISR. The 2901 is utilised to pass the incoming RS232 data stream from the device to the socket of an application running on remote server on the network.The issue I have is that an extra FF byte is ad...

I have a customer which has a custom serial device connected to an IBM 7318 terminal server which is controlled by a custom application running on a Windows server. We are replacing the IBM 7318 with a Cisco 2901 ISR. When the application sets up the...

Hi all,i have a gbic problem with my WS-C3560CG-8PC-S.My original 100FX gbics are not workingMar 30 01:28:41.575: %PHY-4-SFP_NOT_SUPPORTED: The SFP in Gi0/10 is not supportedMar 30 01:28:41.575: %PM-4-ERR_DISABLE: gbic-invalid error detected on Gi0/1...

Difference between sh ip bgp & sh ip route?sh ip bgp :::: loc-rib ?sh ip bgp nei x.x.x.x advertised-routes : adj-rib-in.sh ip bgp nei x.x.x.x recieved-routes : adj-rib-out.sh ip bgp nei x.x.x.x routes : loc-rib ?sh ip route = rib ? if yes does it mea...

 Dear Sir/Madam/Ms, I have a unit of faulty WS-C2960-24TC-L switch with the serial number FCQ1716Y7WH. This unit is not under my support profile, but my customer insists that I help them to do a RMA? How do I proceed? Please advise.Thank yout

Hello,I apologize for the vague title. I am trying to convert my production network from Transparent to Client. All my attempts is giving me problems.I have two C4510R+E core switches which are my VTP Servers, then mostly 2960 Edge switches, with a f...

I have a scenario (topology attached )  Current setup: all vlan defined on sw1 .If any unknown route Sw1 will give to sw2 .Sw2 will give to firewall FW2 . fw2 will give to r2Required :   all vlan except vlan 10  (indicated in green)  has to go to fw1...