Switching

HI Alli configured the route-map on router , route-map Client_side_map permit 20 match ip address Client_side2 set ip next-hop xx.xx.xx.xx  but when i enter show run  i see the following config thats marvel !route-map Client_side_map permit 20 match...

dear all ,i work as a network engineer in a company and need a help.i work in head office and we also have a branch office , we are configuring  a DR site so first we kept all the servers in HO for testing but our clients need to assign a branch offi...

Hi,As the title says, I can't connect to my stack over Telnet nor via the console cables (serial). When I try to connect via telnet, I just get a time-out.When I try to connect via the Console Cable I get the lines "Switch con0 is now available" / "P...

Hi All, I have a scenario where I have two nexus 5596 as upstream and have vPC  in between. downstream is the server hooking to the upstrean both nexus  devices. On Both the Nexus switch the port channel is down and the VPC is also  down. The phys...

Hi..I have upgraded my 3750X switch from c3750e-universalk9-mz.122-53.SE3c3750e-universalk9-mz.122-55.SE5.binlater that by mistake i typed delete /force /recursive flash:now, I am unable to load new IOSerror loading "flash:c3750e-universalk9-mz.122-5...

Hi Allwe currently run our LAN on a 192.168.2.x  255.255.255.0 network. We separated our wireless access points to run off 192.168.3.x network. The WAPs give out dhcp fine, but gets no internet or internal connection.How do we make the .3.x wlan conn...

Any Cisco reps willing to comment if there will be F3 modules which have 10GBase-T interfaces????I know the Nexus 9508 will support both, but I believe it has less features than the 7700, right? How does the 9508 compare to the F2e modules?

Hi,I have a stack on 6 Cisco Catalyst 3750 configured as a VTP server with 6 vlans.It is connected to a Cisco 2811 router with a switching module 16 ports.Can I configure the 2811 as a VTP client of the 3750 stack and configure the Gig port on the sw...

HI Allplease i faced this notification below in my Multilayer Switch ( c3750 ) during console access *May  9 10:33:52.960: %LICENSE-2-EXPIRED: License for feature ipservices 1.0 has expired 1 week  and 2 days ago. UDI=WS-C3750X-24T-E:FAny one can ass...

Hello,I have been beating my head against the wall trying to get this to work, and for the life of me, I cannot. Any help would be GREATLY appreciated..!I am using all four interfaces on the ASA 5510, and am trying to pass traffic between these two i...