Switching

Hi there!I recently discovered on one of our catalyst 6500 switches an increasing number of switch fabric rx errors:switch#show fabric channel-counters slot channel   rxErrors   txErrors    txDrops  lbusDrops    1       0          1          0       ...

Hi Guys,Our company is looking for a switch that's reasonably priced so that we can monitor the bandwidth for different companies on an interface by interface basis. Cost is a little bit of an issue, so I was thinking of something like a 3560GBasical...

Hi Friends,I am trying to analyze the capacity of one of my L3 switches for provisioning a new connectivity. When I check the TCAM util of the device I can see that the QOS aces and the PBR ace's are almost full. On this device however there are no ...

                   We are facing teh issue with high cpu process. In the output could see Cat4k Mgmt LoPri is taking 95% utilization. Model: WS-C4506-E (MPC8548) processor (revision 9)cusred024c4n01#sh process cpu | ex 0.00%CPU utilization for five s...

Hi All,I have a topology were, im using a Switcg 3560(L2), and a Router.. and 10 Systems connected to the Switch ( Access Ports- Port Fast configured).Highlevel Diagram:SYSTEMS(A) (VLAN100) >>ACCESS>> Switch(Sw1) >>>> TRUNK>>>> Router(R1)Eveerything ...

I can not connect my WUMC710 wireless-AC Universal Media Connector to my routerI have tried on 2 totaly different networks with different routers by using the WPS Switch on the devices but it does not get noticed by the routers!Also i tried to set up...

Yesterday I upgraded one of our 3750X switch stacks (8 total switches) to version 150-2.SE4 (c3750e-universalk9-mz.150-2.SE4.bin).  I noticed that after the upgrade I receive a lot of log entries of this type event:Aug 24 08:57:04:  Failed to send hr...

Our client has many remote sites in different location and each site is with a WAN router and a 3750 X switch. Switch is working as a layer 3 switch and the uplink connected to WAN router is a layer 3 interface. They have configuered " Spanning tree ...

Last week, I install a new switch at one of our branches. Since then, when you connect to the public wireless network you get limited or no connectivity. I was working with the old switch.. Any help is greatly appreciated.Thanks,DJ

When upgrading a Catalyst 3750 or 3560 with the archive command from tftp, it downloads the image twice. Is it doing a file check? Why does it need to download twice?Thanks,W

I have a couple stacks of 3750x 24 port switches, I am seeing a decent amount of Outdiscards on my interfaces. The research I have done indicates this could be a QoS Problem, looked like the buffer ques were set to low... After tweeking them I still ...

Please someone answer why the show mac-address-table would not output any information on a network. I have just taken the CCNA exam. The network had 4 switches connected by trunks. I needed to find out what interfaces had for a mac address. I used th...