Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

                Hi all,We are getting some error logs on Nexus VDC,as follows:     2012 Nov 23 08:49:11 N7K_B-Network_Center_B %$ VDC-3 %$ last message repeated 6 times2012 Nov 23 08:50:21 N7K_B-Network_Center_B %$ VDC-3 %$ last message repeated 7 ti...

I want to make sure I understand this correctly.  I have 2 3750's one is an 3750E the other one is a G... Since they are 2 different versions Do I need to correct ios for each for example my 3750E switch i would have IP BASEc3750e-ipbasek9-mz.122-53....

raine1378 by Beginner
  • 1250 Views
  • 4 replies
  • 0 Helpful votes

Hi Everyone,I have stack of 2 cables.I connected 2 ports of switch with each other as shwon below3750TS#sh cdp neiCapability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge                  S - Switch, H - Host, I - IGMP, r - Repeater, P...

mahesh18 by Frequent Contributor
  • 1432 Views
  • 2 replies
  • 0 Helpful votes

currenly running a C6509E, with a WS-SUP720-3B running IOS level S72033-adventerprisek9_wan-MZ.122-22.SXH3.  I want to install a WS-X6748-GE-TX blade and would like NOT to have to upgrade IOS at this time.  Future migrations are planned.  Can this be...

jcowtan by Beginner
  • 1367 Views
  • 6 replies
  • 0 Helpful votes

Resolved! Symmetric Routing

I am interested in achieving symmetric routingI am running BGP, I have two CE routers connected to the same ISP. I am using MED to influence the traffic inbound, so each router receives 1/2 of the advertised traffic.I have 2 iBGP speaking core switch...

We have deployed ARP inspection withinour access switches (Cisco 3750's w/ IOS 12.2(35)). We had no issues running ARP inspection with no modification to the standard thresholds, until we started deploying Window 7.When a employee does searches withi...

I am trying to configure the wireless on my cisco 857W. The clients associates with router but they can't go on internet.Building configuration...Current configuration : 4123 bytes!! Last configuration change at 12:45:15 CET Sun Nov 18 2012 by simone...

Hi,I would like to get complete detail for the command above.Please find some part of the command output for my switch.vlan   mac address     type        protocols               port-------+---------------+--------+---------------------+-------------...

Hi,If I have two switches that are in transparent mode with exact same vlans and a port channel between them with trunk enabled are they able to carry vlan data between themselves?Sent from Cisco Technical Support iPhone App

dazzpowder by Beginner
  • 1890 Views
  • 3 replies
  • 0 Helpful votes

Hi,Im not too sure if Im just being a an idiot but it is possible to create 2 static default routes using PBR isnt it? I'm just not 100% if it is only for use with route redistribtion and I cant seem to find the info that I need online. I have a requ...

itadmin by Beginner
  • 378 Views
  • 2 replies
  • 0 Helpful votes