Switching

Before I start, I want to talk about the set up in my lab. I have router 1 connect to router 2 via the 192.168.1.0/24 network. Router 2 has five loopbacks 10.1.1.1/24; 10.1.2.1/24; 10.1.3.1/24; 10.1.4.1/24; 192.168.2.1/24. Both routers have configure...

New to Cisco and want to know if I can segment a port. I have two vlans. I have one internet connection at the opposite end of the building. Can the port the internet is connected to serve both Vlans? How is this setup?

My SG200-50P Switch Log appears as follows with Random ports going up and down. I am trying to find out if this links to another problem I'm having with a Client Server software locking up on the client end. The hardware, thin clients and desktops, a...

Hi , we observe that the process platform causes about 50% cpu load of our Nexus 7010.Could not find any information for what this process is responsible to find out the root cause of the high cpu load.Any idea out thereThxHubert

                   HI All - I have observed a situation where one of our cisco switch 3560 is rebooting daily at periodic times.We have checked the power cables and source everything is fine and still clueless whats causing the issue.000004: *Mar  1 ...

hi i have new project in hospital with the bellow product :20 X WS-C2960-24TC-S2 X WS-C3750X-48T-S2 X WS-C2960S-24TS-Si need to configure this switch in order to work first the 2 core switch for redundancy then each catalyst switch 2960 connected to ...

According to the Cisco documentation below • When configuring Layer 3 EtherChannels, you must manually create the port channel logicalinterface first (see the “Configuring Port Channel Logical Interfaces for Layer 3 EtherChannels” section on page 12-...

Hi,I have CISCO catalyst with VLANs (VLAN ID 33, 36, 40-53) configured. I need to configure port mirroring in Switch 3750 for NAC (Network Access Control).  I need to Monitor all the VLANs. Here is the SPAN configuration of switch:Interface fa 1/0/8D...

Guys Good afternoonI would like to know if somebody can help me solving this problem.Deal about a datacenter network where there is a switch 6509. In this switch at G2/41 interface is connected a server. My problem is the increase of input drops in t...

Using a 4948E switch with FastEthernet1 as the management interface which uses the VRF mgmtVrf. I cannot get DNS resolution to work for some reason.I am using code enterprise 15.1-2.SG and here are the relevant config snippets:ip domain-lookup source...

I have a connection that is loosing packets, my show interface output below summarises the interface where i believe the problem is occuring. Please share some suggestions. My Hardware is 6509 running 12.2