Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Recently we observed that newly installed WS-C3560CG-8PC access switches are able to communicate without a default route or default gateway.The 3650 switches are used as a layer2 access switch behind a layer3 distribution/core. They have only the man...

m.kafka by Level 4
  • 1328 Views
  • 3 replies
  • 0 Helpful votes

Hi everybodyI am reading about netflow for my Tshot exam. I have few questions as to what we consider a  unique flow in route cache ?H1-------ethernet----------R1.H1 --> 199.199.199.1R1----> 199.199.199.2.We configured following on R1:int f0/0 ( the ...

sarahr202 by Level 5
  • 3315 Views
  • 9 replies
  • 0 Helpful votes

Hi, forgive the rudimentary question, but here is the issue I am facing.  I just got a brand new switch and was configuring this and somehow I am not able to get into this via telnet or console.  I was hoping to get into ROMMON mode and just redo the...

If I'm upgrading dual redundant power supplies in a Catalyst 4507 from 1000W (data) to 1400W (data), can it be done without taking the switch through a power cycle? I'm guessing no as I read that the switch will not recognize a 1400W PSU in bay 2 if ...

gmckay2e2 by Level 1
  • 1143 Views
  • 2 replies
  • 0 Helpful votes

Hello,Has anyone an idea, why the Switch 6500 sends every 90 seconds a arp request? The cpu load is nearly 100% while this request occur.We haven’t any arp timer configured, we use the default timer 4 hr.- for all arp entry’s the switch will generate...

mgoerke by Level 1
  • 1249 Views
  • 3 replies
  • 0 Helpful votes

Hi,I have a Cisco 6509 with IOS "s222-ipservicesk9_wan-mz.122-18.SXF16.bin"I need to enable dot1x on user's ports on the switch. each user is connected to the switch through the IP phone. I just found out that I can not enabled dot1x on trunk port. I...

Experts, Is some packet loss on a campus network natural or should a network see no packet loss at all if properly configured? I'm asking because I performed a file transfer (900 Mb) from one host to another on the same switch (3750X), same VLAN with...