Switching

Hello Cisco Team,  We are trying to copy the file from USB flash drive on to the Cisco 9300 Switch but seeing below error , could someone please guide us on this issue. This is for upgrading the current Stack switch from version 16.6.6 to 17.06.05 Sw...

I am having a problem with the 2504 WLC in packet tracer 7.2.2.0418.  The issue is once I finish the initial setup and the wlc reboots, it never comes back up.  I can't ping it, or connect via web address.  I have verified connectivity before running...

Hi,is it possible to connect 10/100 Mbps devices to multigig switch Thanks

Hello, I'm learning how to network so I put together a packet tracer configurations.  I'm not sure if i'm doing this right if someone can take a look.  I think my configuration should take me out to the internet but I might be missing something.  Tha...

1) Regarding LACP, what is the best of tuning the shortest possible link-bundling time? Is it to have both ends as "active"? I also configured "lacp rate fast" but I believe this is more for failover.2) In "On" mode (i.e. not LACP or PAGP) commonly s...

actually i have one query about Primary & Secondary Switch. So question is : Whenever we make Primary Switch & Secondary Switch. Then let's assume we make some vlan configuration on primary switch and after sometime primary down then we need to make ...

Hi thereI have googled so much about this subject, but all results lead to dead end. The system we are setting up with CBS350-48P switches requires jumbo frames with at least 8k mtu. With this specific switch, how can I set mtu port by port or system...

Hello! I have multiple wireless access points on different interfaces on my cisco 2960x switch. When using DHCP Snooping and client moving from one AP to another, the client device mac-address is essentially changing ports.Will it be problem? Will th...

What does a C9200-24T-E look like? Diagram or photo?

Hi all.  I am trying to copy all files from a flash: on a CME to a usbflash drive.  I am able to do so, but only one at a time.  Is there a away to copy all files at one time so I dont have to name them individually when copying all of them over?  Th...

We just purchased and received 2 C9500-16X switches (all 10G ports).We're looking to stack them with the Virtual StackWise technology, however I'm having trouble locating best practices online regarding how much bandwidth should be sufficient.If we h...

Hi guys, I trying to use USB device for ESS 3300 switch but the switch is not supporting commands related to USB. Commands like show platform usb staus , platform usb disable are not being recognized by the switch. It'll be really helpful if anyone c...