Switching

Hello everyone,from cisco site:You can re-enable a port by using the shutdown and  no  shutdown interface configuration commands, or you can clear error disable  for VLANs by using the clear errdisable  interface command. This example shows how to ...

Hello, We have Three locations (A,B,C) across campus. Location A is Main Location, While B & C are remote locations. Distance among all locations approx. 2 miles.I want 10G Fiber among these three locations. I am taking 4510+E with SUP 7E with Redund...

Hi everybody. How is everyone doing?When we use command for example " show ip bgp neighbor 2.2.2.2 received-routes" on Router R1,   does this command extract its output from BGP table?My book says the above command will show all the routes received f...

Hello,I have a scenario where I need to shape and queue traffic on a physical interface and as well on sub interfaces.  Here is what I currently have setup:g0/1 - main interface for internet trafficg0/0 main lan interface for most users, servers, etc...

cpp arp, i want to make control plane policing for the arp packets but i am bot sure how many mbits per second is ok with that? do you have any idea?

Hii,I know there are a lot of EIGRP variance posts in this forum. But a good friend of mine stumblede across a scenario where the FS does not get installed in the RIB.Topology:Configurations:R1interface Serial0/0 description ---- Link to R3 ----> ip ...

Hi, Both regular IP traffic and ICMP traffic are passing through the source port. C6509 provides the option of filtering vlan traffic during monitoring. But I don't have vlan traffic. qa-c6509-c(config)#monitor session 1 filter ?  vlan  SPAN filter V...

Hi Guys, I´m looking for an IOS on a 7609 SUP720/MSF3 that supports the NAT-PT feature (IPv4 to IPv6 translation). I searched on the Cisco Feature Navigator but the tool didn´t show up any IOS for the 760x platforms. I only got the feature "NAT-PT: S...